RAD Data comm Getting Started, Turning IPmux-16 Off, To set all passwords to the default value

Chapter 3 Operation IPmux-16Installation and Operation Manual

➤To set all passwords to the default value (xxxxxxxxxx):

1.Enter su for User Name.

2.Delete the unit’s configuration through the Configuration screens.

Note Deleting the unit’s configuration using <Cntl+A> and choosing 4 in the Boot Menu does not set the passwords to the default value.

➤If a user forgets his password:

•Consult Technical Support at RAD for further assistance (send email to support@rad.co.il).

Turning IPmux-16 Off

➤To power off the unit:

1.If you are using a terminal connection, press escape until you return to the main menu and press 4. Exit.

2.Switch PS1 (and PS2 if connected) to OFF.

3.4 Getting Started

After installation, there are no special operating procedures for IPmux-16. Once it is powered up, the unit operates automatically. Proper operation is indicated by the front-panel LED indicators (Figure 3-1and Figure 3-2). The unit operational status can be monitored constantly.

If required, the IPmux-16 can be reconfigured. Both the IPmux-16 configuration and monitoring operations are performed locally from an ASCII terminal, Telnet or NMS connected to the Control Port. Detailed configuration procedures are given later in this chapter. The following functions are supported:

•View system information

•Modify configuration and mode of operation, including setting system default values

•View statistics and status

•Perform diagnostics.

IPmux-16 configuration and system monitoring, including troubleshooting procedures, can also be performed from a remote site using a Telnet application or RADview (RAD’s HP OpenView based SNMP).

Note Telnet and the local terminal cannot work simultaneously.

3-4 Getting Started