Fellowes 75Cs manual English, Limited Product Warranty

Page 2

ENGLISH

Model 75Cs

A.

G.

 

 

 

B.

 

 

C.

H.

KEY

 

D.

 

Advanced product features

SafeSense® Technology

Stops shredding immediately when hands touch the paper opening.

SET-UP AND TESTING

 

 

1

2

3

Turn the shredder ON

Touch test area and

SafeSense® is active

(I) to activate

look for the SafeSense®

and working properly

SafeSense®

indicator to illuminate

 

I.

 

 

A. SafeSense® Technology

G. Disconnect power switch

I. Control switch and Indicator lights

For more information about all of Fellowes Advanced Product Features go to www.fellowes.com

E.

 

 

B. Paper entry

1.

OFF

 

 

 

 

I

1. Auto-On (green)

 

 

C. See safety instructions

 

 

 

2.

ON

 

 

 

 

O

2. OFF

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

D. Card/CD entry

H. SafeSense® override switch

R

3. Reverse

F.

 

 

 

E. Window

 

 

 

 

 

 

 

 

 

 

 

 

 

4.

Overheat (red)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

F. Pull-out bin

 

 

 

 

 

 

 

 

 

 

 

 

 

5.

Bin Open (red)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Active

Not active

 

6.

Remove Paper (red)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

7.

SafeSense® (yellow)

PRODUCT MAINTENANCE

OILING SHREDDER

All cross-cut shredders require oil for peak performance. If not oiled, a machine may experience diminished sheet capacity, intrusive noise when shredding and could ultimately stop running. To avoid these problems, we recommend you oil your shredder each time you empty your waste bin.

FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE

1 2 3

Cleaning Auto-Start Infrared Sensors

Paper detection sensors are designed for maintenance free operation. However, on rare occasions, the sensors may become blocked by paper dust causing the motor to run even if there is no paper present.

(Note: two paper detection sensors are located in the center of the paper entry).

TO CLEAN THE SENSORS

 

 

 

1

2

3

4

CAPABILITIES

Set to Off (O)

*Apply oil across entry

Press and hold Reverse

 

 

(R) 2-3 seconds

Set to Off (O)

Locate Auto-start

Dip cotton swab in

Using cotton swab, wipe

and unplug

infrared sensor

rubbing alcohol

away any contamination

 

 

 

from the paper sensors

Will shred: Paper, credit cards, CD/DVD, staples, small paper clips and junk mail

Will not shred: Continuous forms, adhesive labels, transparencies, newspaper, cardboard, large paper clips, laminates or plastic other than noted above

Paper shred size:

 

Cross-Cut

4mm x 38mm

Maximum:

 

Sheets per pass

12*

Cards/CDs per pass

1*

Paper entry width

230mm

*A4 (70g), paper at 220-240V/50/60 Hz, 1.5Amps; heavier paper, humidity or other than rated voltage may reduce capacity. Maximum recommended daily usage rates: 500 sheets

per day; 25 cards; 10 CDs. 12 sheets per pass.

*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250

TROUBLESHOOTING

Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This

indicator will remain illuminated and the shredder will not operate for the duration of the recovery time. See Basic Shredding Operation for more information about the continuous operation and recovery time for this shredder.

IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!

Bin Open: The shredder will not run if the bin is open. When illuminated, close the bin to resume shredding.

Remove Paper: When illuminated, press reverse (R) and remove paper. Reduce paper quantity to an acceptable amount and refeed into paper entry.

• Operation, maintenance, and service requirements are covered in the instruction manual. Read the entire instruction manual before operating shredders.

Keep away from children and pets. Keep hands away from paper entry. Always set to off or unplug when not in use.

• Keep foreign objects – gloves, jewelry, clothing, hair, etc. – away from shredder openings. If object enters top opening, switch to Reverse (R) to back out object.

• Never use aerosol products, petroleum based lubricants or other flammable products on or near shredder. Do not use canned air on shredder.

Do not use if damaged or defective. Do not disassemble shredder.

Do not place near or over heat source or water.

BASIC SHREDDING OPERATION

This shredder has a Disconnect Power Switch (G) that must be in the ON (I) position to operate shredder. In case of emergency, move switch to OFF (O) position. This action will stop shredder immediately.

Avoid touching exposed cutting blades under shredder head.

Shredder must be plugged into a properly grounded wall outlet or socket of the voltage and amperage designated on the label. The grounded outlet or socket must be installed near the equipment and easily accessible. Energy converters, transformers, or extension cords should not be used with this product.

FIRE HAZARD – Do NOT shred greeting cards with sound chips or batteries.

For indoor use only.

Unplug shredder before cleaning or servicing.

SafeSense® Indicator: If hands are too close to the paper entry, the SafeSense® indicator will illuminate and the shredder will stop shredding.

PAPER JAM

 

 

 

 

 

1

2

3

4

5

6

Press and hold

Alternate slowly back and forth

Set to Off (O)

Gently pull uncut

Set to Auto-On (I) and

Reverse (R) for 2-3

 

and unplug

paper from paper

resume shredding

seconds

 

 

entry. Plug in

 

LIMITED PRODUCT WARRANTY

Continuous operation: Up to 12 minute maximum

NOTE: Shredder runs briefly after each pass to clear entry. Continuous operation beyond 12-minutes will trigger

20-minute cool down period.

PAPER OR CD/CARD

1

Plug in and put disconnect power switch in ON (I) position

2

3

4

5

 

 

or

 

Set to Auto-On (I)

Feed paper straight into

Feed into card/CD

When finished

 

paper entry and release

entry and release

shredding set to

 

 

 

OFF (O)

Limited Warranty: Fellowes, Inc. (“Fellowes”) warrants the parts of the machine to be free of defects in material and workmanship and provides service and support for 2 years from the date of purchase by the original consumer. Fellowes warrants the cutting blades of the machine to be free from defects in material and workmanship for 5 years from the date of purchase by the original consumer. If any part is found to be defective during the warranty period, your sole and exclusive remedy will be repair or replacement, at Fellowes’ option and expense, of the defective part. This warranty does not apply in cases of abuse, mishandling, failure to comply with product usage standards, shredder operation using an improper power supply (other than listed on the label), or unauthorized repair. Fellowes reserves the right to charge the consumers for any additional costs

incurred by Fellowes to provide parts or services outside of the country where the shredder is initially sold by an authorized reseller. ANY IMPLIED WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable for any consequential or incidental damages attributable to this product. This warranty gives you specific legal rights. The duration, terms, and conditions of this warranty are valid worldwide, except where different limitations, restrictions, or conditions may be required by local law. For more details or to obtain service under this warranty, please contact us or your dealer.

2

3

75Cs_406144_REVD_041013_18L.indd 2-3

4/11/13 3:51 PM

Image 2
Contents Powershred 75Cs Limited Product Warranty EnglishFrançais Garantie Limitée DU ProduitEspañol Garantía LimitadaDeutsch Risoluzione Guasti ItalianoCaratteristiche Funzionamento Base DEL DistruggidocumentiProductonderhoud Problemen OplossenBeperkte Productgarantie MogelijkhedenBegränsad Produktgaranti Dansk Begrænset ProduktgarantiTuotteen Huolto SuomiSelitykset OminaisuudetNorsk Begrenset ProduktgarantiPolski Ograniczona Gwarancja NA ProduktРусский Ограниченная Гарантия НА ИзделиеΔυνατοτητεσ ΕλληνικαΣυντηρηση Προιοντοσ Επιλυση ΠροβληματωνTürkçe Ürünün Sinirli GarantİsİČesky Omezená Záruka NA VýrobekSlovenčina Magyar Korlátozott TermékgaranciaGarantia Limitada DE Produto E.E
Related manuals
Manual 4 pages 27.64 Kb