Cisco Systems SFS 3001 quick start FCC Statement Safety Information, Electrical Cautions

Page 5

v

Regulatory Notices

FCC Statement

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

Safety Information

“Electrical Cautions” on page v

“General Cautions” on page vii

“Laser Cautions” on page vii

Electrical Cautions

Use only the power cable provided with your Topspin system. Inspect the power cord and determine if it provides the proper plug and is appropriately certified for use with your electrical system. Discard the cord if it is inappropriate for your country’s electrical system and obtain the proper cord, as required by your national electrical codes or ordinances.

CAUTION: Grounding is supplied by the ground-prong on the 3-prong power cable. Do not attach a separate ground cable. Do not use adapter plugs. Do not remove the ground prong from the cable.

Image 5
Contents Part Number OL-7712-01 Product ID Page Contents Regulatory Notices Page Electrical Cautions FCC Statement Safety InformationPage Laser Cautions General CautionsLaser Specs Contact InformationPrepare the Site Topspin 90 Quick StartPrepare for the Installation Install the Topspin 90 in an Equipment RackRack Mount Installation RequirementsSeparate Brackets 3Holding Rack Bracket Against Inside of Rack Connect Management Ports Install Expansion Modules OptionalCable the Switch Configure Basic Connectivity Topspin-90config#interface mgmt-ethernet Enter the interface mgmt-ethernet commandTopspin-90#copy running-config startup-config Assigning an Address Dynamically Dhcp# mount /mnt/cdrom Connect and Configure InfiniBand HostsTopspin-90#show interface mgmt-ethernet # cdmount ./tsinstall 7Fully Installed IB Cable with Pinch Connector Install the Element Manager GUIPrograms -Topspin Element Manager -TopspinEM Launch Chassis ManagerTopspinEM Configure Additional Settings Layer 2 Bridging Procedure Optional Configure the Ethernet GatewayEnter ifconfig eth# subnet# netmask # Use the broadcast-forwarding commandEnter interface ethernet slot/port Enter interface gateway physical slot#Topspin-90#show fc srp target Configure the Fibre Channel Gateway OptionalTopspin-90#configure terminal Description keyword Discover-itl keyword Topspin-90#show fc srp initiatorSRP ITL Topspin-90#show fc srp itlGateway-portmask-policy keyword Page Index