Figure 6-9. Optional PCIe Expansion-Card Central Riser Board Components
1
2
1 | slot 1 | 2 | system board connector |
Disabling a Forgotten Password
The system's software security features include a system password and a setup password, which are discussed in detail in "Using the System Setup Program" on page 37. The password jumper enables these password features or disables them and clears any password(s) currently in use.
NOTICE: See "Protecting Against Electrostatic Discharge" in the safety instructions in your Product Information Guide.
1Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
2Open the system. See "Opening and Closing the System" on page 54.
3Lift up the memory module shroud.
4Remove the jumper plug from the password jumper.
See Figure
5Close the system.
6Reconnect your system and peripherals to their electrical outlets, and turn on the system.
The existing passwords are not disabled (erased) until the system boots with the password jumper plug removed. However, before you assign a new system and/or setup password, you must install the jumper plug.
NOTE: If you assign a new system and/or setup password with the jumper plug still removed, the system disables the new password(s) the next time it boots.
7Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
144