Dell 2950 PCIe Degraded Link Width, Error Embedded, Bus#nn/Dev#nn/Funcn, Expected Link Width is n

Table 1-7. System Messages (continued)

Message	Causes	Corrective Actions
PCIe Degraded Link Width	Faulty or improperly installed PCIe	Reseat the PCIe card in the specified
Error: Embedded	card in the specified slot.	slot number. See "Expansion Cards" on
Bus#nn/Dev#nn/Funcn		page 76. If the problem persists, see
Expected Link Width is n		"Getting Help" on page 147.
Actual Link Width is n
PCIe Degraded Link Width	Faulty or improperly installed PCIe	Reseat the PCIe card in the specified
Error: Slot n	card in the specified slot.	slot number. See "Expansion Cards" on
Expected Link Width is n		page 76. If the problem persists, see
		"Getting Help" on page 147.
Actual Link Width is n
PCIe Training Error:	Faulty or improperly installed PCIe	Reseat the PCIe card in the specified
Embedded	card in the specified slot.	slot number. See "Expansion Cards" on
Bus#nn/Dev#nn/Funcn		page 76. If the problem persists, see
PCIe Training Error:		"Getting Help" on page 147.
Slot n
PCI BIOS failed to install	PCI device BIOS (Option ROM)	Reseat the expansion card(s). Ensure
	checksum failure is detected during	that all appropriate cables are securely
	shadowing.	connected to the expansion card(s). If
	Loose cables to expansion card(s);	the problem persists, see
		"Troubleshooting Expansion Cards" on
	faulty or improperly installed
		page 127.
	expansion card(s).
Plug & Play Configuration	Error encountered in initializing PCI	Install the NVRAM_CLR jumper and
Error	device; faulty system board.	reboot the system. See Figure 6-1 for
		jumper location. If the problem persists,
		see "Troubleshooting Expansion Cards"
		on page 127.

Read fault

Requested sector not found

The operating system cannot read from the diskette or hard drive, the system could not find a particular sector on the disk, or the requested sector is defective.

Replace the diskette. Ensure that the diskette and hard drive cables are properly connected. See "Troubleshooting a USB Device" on page 115, or "Troubleshooting a Hard Drive" on page 124 for the appropriate drive(s) installed in your system.

Remote	configuration	System unable to process Remote	Retry Remote Configuration.
update	attempt failed	Configuration request

32

About Your System