Dell 2950 Removing the Cooling Shroud, Installing the Cooling Shroud, Shroud hinges Fan bracket

Removing the Cooling Shroud

1The cooling shroud is secured with a latch at the end of the shroud. Release the latch by pulling it towards the outside wall of the chassis. See Figure 3-10.

2Rotate the shroud upward and toward the front of the system on its hinges, and then lift the shroud out of the system.

Figure 3-10. Removing and Installing the Cooling Shroud

2 3

1

4

				5
1	shroud pivots (2)	2	cooling shroud	3	release latch
4	shroud hinges (2)	5	fan bracket

Installing the Cooling Shroud

1Align the hinges on the shroud pivots located on either end of the fan bracket. See Figure 3-10.

2Slowly lower the shroud straight down into the system until the fan connector engages and the latches snap into place.

Installing System Components

67