4Prepare the tape drive for installation.
Ground yourself by touching an unpainted metal surface on the back of the system, unpack the drive (and controller card, if applicable), and compare the jumper and switch settings with those in the drive documentation.
5Aligning the four holes on the tape drive with the four screw holes on the tape drive rails, affix the rails to the drive.
6Insert the tape drive along the rails in the media bay. See Figure
Figure 3-25. Removing and Installing an Internal SCSI Tape Drive
1 | 3 |
| 2 |
4
1 | screws (4) | 2 | tape drive rails (2) | 3 | rail release tabs (2) |
4tape drive
7Route the tape drive's SCSI interface cable through the tape drive cable retention bracket and connect it to the connector on the SCSI controller card. See "Removing and Replacing the Tape Drive Cable Retention Bracket" on page 88.
8Connect the tape drive power cable to the tape drive power connector on the backplane. See Figure
9Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
10Perform a tape backup and verification test with the drive as instructed in the software documentation that came with the drive.
Installing System Components
87