Dell 2950 owner manual Installing the Left Riser Board, Riser securing tabs Riser securing slots

Figure 3-31. Replacing the Left Riser Board

3 4

5

	2
	1
1	riser release pin	2	expansion-card rails	3	expansion-card cage
4	riser securing tabs (6)	5	riser securing slots (6)

Installing the Left Riser Board

CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. See your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting against electrostatic discharge.

1Place the riser board in the expansion-card cage so that the six securing tabs are fully inserted in the six securing slots on the riser board. See Figure 3-31.

2Slide the riser board toward the expansion card openings until you feel the riser-board release pin snap into place.

3Replace the expansion-card cage. See "Replacing the Expansion-Card Cage" on page 79.

4Install all expansion cards in the expansion-card slots. See "Installing an Expansion Card" on page 76.

5Close the system. See "Closing the System" on page 55.

Installing System Components

99