Chapter 3 Operation Instruction
In this Chapter, you will find a detailed introduction about the operation through the LCD display.
3-1 LCD display instruction
The printer is equipped with an LCD Display and four buttons, which give access to printer menus. Turn the printer power switch on, the printer system will detect the printer status and feedback the error messages on the LCD display if any error would occur. Some errors may be resolved by troubleshooting instructions from the LCD display. If everything is normal, then the LCD display will display: “Ready”.
[ ◄ ] : | Return to the previous option |
[ ► ] : | Go to the next option |
[OK] / [●] : | Go to the next setting menu |
[ESC] / [－] : | Return to the previous setting menu |
3-2 Operation instruction
When the LCD display shows “READY”, you can press ”OK” button to check the printer status or to clean the printer. It will go to the main setting menu as follows.
Main Menu | Sub Menu | Description |
|
| |
．DEVICE INFO | ．．RIBBON TYPE | The ribbon type in the printer. |
| ||
|
|
| |||
| ．．CARD TYPE | The card thickness setting for the | |||
|
| printer. |
|
|
|
| ．．MODEL NAME | The printer model name. |
| ||
|
|
|
|
| |
| ．．FW VERSION | The firmware version. |
|
| |
|
|
| |||
| ．．IC CARD R/W | The IC card reading/writing function. | |||
|
| (YES/NO) |
|
| |
|
|
|
|
|
|
| ．．MAG CARD R/W | The | magnetic | stripe | card |
|
| reading/writing function. (YES/NO) | |||
| ．．RF CARD R/W | The contactless card reading/writing | |||
|
| function. (YES/NO) |
|
| |
|
|
| |||
| ．．RIBBON CH1 | The ribbon sensor switch. You can | |||
|
| select the sensor CH1 or CH2 here. | |||
|
| (CH1/CH2) |
|
| |
|
|
|
|
|
|
29www.hi-ti.com