Hi-Touch Imaging Technologies CS-320 manual Appearance of CS-310/320 CS-310/320 Front side

Page 7

1-2 Appearance of CS-310/320

zCS-310/320 Front side*

A. Card Input Hopper

This is the Card Input Hopper for storing blank cards. Please insert the blank cards gently and remember to shield them with the built-in cover to avoid any dust entering in there.

B. Card thickness selection button

HiTi CS-310/320 provides four selections for thickness: 0.3 mm (10 mil), 0.5 mm (20 mil), 0.8 mm (30 mil) and 1.0 mm (40 mil). Please move and slide the selector for thickness to the correct thickness position, which matches the thickness of the cards in the Card Input Hopper.

Remark: The Thickness tolerance of cards are 03mm +/-0.02mm (0.28 ~ 0.32mm), 0.5mm +/-0.03mm (0.47 ~ 0.53mm), 0.8mm +/-0.04mm (0.76 ~ 0.84mm), 1.0mm +/-0.05mm (0.95 ~ 1.05mm). If your card thickness is out of the above specification, it may cause significant damage to HiTi ribbon; may reduce the life span of HiTi Card Printer; may damage print head; and may cause unsatisfactory color performance.

C. LCD Display:

The status of the printer is displayed on the LCD screen, you can use [◄], [►], [OK], [ESC] buttons to control the operation of the printer and for troubleshooting.

D. ID Button

To replace ribbon cartridges, please gently slide the ID button on the top of the printer to open the ribbon door.

E. Rejected box

When an error occurs during the reading/writing process for smart chips and/or magnetic cards, these cards are ejected into a rejected box, which holds about 20 cards. The system will show an error message when cards accumulate to around 20 pieces in the rejected box. Please remove these cards to continue the printing task.

F. Card Output Hopper

The printed cards will be placed here.

*For CS310i / CS320i (Card Printer + Laminator), the front view is shown as follows.

Laminator

Card Printer

7

www.hi-ti.com

Image 7
Contents HiTi Card Printer CS-310/320 Acknowledgements Safety Instructions Chapter Troubleshooting Error Message & SolutionOperation Instruction LCD Display Instruction Instruction HiTi Card Printer CS-310/320 FeaturesCheck Accessories Hardware InstallationCard Input Hopper Appearance of CS-310/320 CS-310/320 Front sideSpecification Label Power SwitchPower Socket USB ConnectorControl Button Control PanelLED Light LCD displayInstall Power Cord & USB Cable Install Cleaning Roller Contact smart card installation Magnetic stripe card Install Card & RibbonInstallation Ribbon Installation Software Installation Install Driver Windows 2000/XP/Vista Uninstall Driver Select Software / CardDesiree CS and install Install CardDesiree CSDriver Instruction ABC Device OptionAlways on Printing Area Setting Edit Area Color Color preference setting There are four optionsSkin Tone Adjuster Tools Abcdefrg Magnetic EncodingImport/Export About LaminationOperation instruction LCD display instruction..CARD OUT SNR How to maintain your printer 1Clean Cleaning Roller Stand alone mode 2Clean Print PathPC link mode 3Clean TPH Head 4Clean Air Filter Cleaning Card-insert Mechanism Clean Ribbon Sensors Error Message and Solution TroubleshootingPlease install a new ribbon Auto Remove Card Press OK, the card Controller Error Message Possible Causes Solutions Ribbon CAM TPH Error Appendix a CS-310/320 Specification Appendix B Safety Instructions FCC Information Appendix C FCC Compliance StatementPage Page CE Information Page China Support ProcessWeb Support Contact Information TaiwanLatin America Middle East & North AfricaIndia Appendix E Order Information