4-2 Clean Print Path
zIn Stand alone mode
1.Turn the power switch of the printer on.
2.The printer will check the system status automatically, and show “Ready” on the LCD display.
3.Click the [<] or [>] button, and select [Cleaning mode] to begin the cleaning process.
4.The cleaning process will be displayed on the LCD display. Please follow the instructions step by step.
a.Take off the ribbon cassette.
b.Please remove the 3M
c.Press the [OK] button to begin the cleaning process.
5.The Cleaning process is finished.
*For CS310i / CS320i, HiTi recommends users to implement the above procedures to clean the print path of the card printer before cleaning the print path of the laminator.
The procedures for cleaing the print path of the laminator are shown as follows:
a.Follow Step 1 – 3 and the LCD will show [Cleaning Path].
b.Press [<] or [>] button to select [Lamination Cleaning Path], then press [OK]
c.Follow Step 4 – 5 to complete the cleaing process.
zIn PC link mode
1.Turn the power switch of the printer on.
2.Connect the printer to the PC with the USB cable.
3.Find the driver settings under Control Panel/ Printers. Choose HiTi
4.Select the [Tools] and press the [Cleaning Tools] button.
5.Follow the cleaning process,
a.Open the cover of the printer.
b.Take off the ribbon cassette.
c.Put the cleaning card into the Card Input Hopper. Please remove the release paper from the cleaning card and put the cleaning card into the Card Input Hopper.
d.Press the [Cleaning] button to begin the cleaning process.
6.The Cleaning process is finished.
*Clean print path in PC link mode is available for Card printer only NOT for CS310i / CS320i.
Notices:
1.Do not put your hand into the card printer during the cleaning process.
2.Do not close the cover of the printer during the cleaning process.
3.Do not turn off the power or unplug the USB cable during the cleaning process.
33www.hi-ti.com