Hand Held Products 5700 manual Buffered Scans Selection, Code I.D. Transmit Selection

Buffered Scans Selection

When enabled, this selection allows the scanner to accept a second scan while the current scan is transmitted to the host terminal (buffering of scanned data). When disabled, the scanner cannot accept additional scans until the current scan is transmitted to the host. Default = Enable.

✱ Enable Disable

Code I.D. Transmit Selection

This allows you to enable or disable transmission of a Code I.D. before the decoded bar code symbology. (See the Symbology Chart on page 2–7 for the single character code that identifies each symbology.)

Enable ✱ Disable

AIM I.D. Transmit Selection

This selection allows you to enable or disable transmission of an AIM I.D. before the decoded bar code symbology. (See AIM Guidelines on Symbology Identifiers for more information on the AIM symbology ID characters.) Default = Disable.

Enable ✱ Disable

Function Code Transmit Selection

When this selection is enabled, and function codes are contained within the scanned data, the scanner transmits the key code (which corresponds to the decoded ASCII function code) to the terminal. ASCII function codes are represented by the HEX values 00–1F. (Charts of these function codes are shown in Section 6, Supported Interface Keys.)

	✱ Enable	Disable
2–10	SCANTEAM 5700 User’s Guide