3Remove all expansion cards installed in the system. See "Removing an Expansion Card" on page 78.
4Let the system dry thoroughly for at least 24 hours.
5Close the system. See "Opening and Closing the System" on page 54.
6Reconnect the system to the electrical outlet, and turn on the system and attached peripherals. If the system does not start properly, see "Getting Help" on page 147.
7If the system starts properly, shut down the system and reinstall all of the expansion cards that you removed. See "Installing an Expansion Card" on page 76.
8Run the appropriate online diagnostic test. See "Using Server Administrator Diagnostics" on page 131. If the tests fail, see "Getting Help" on page 147.
Troubleshooting a Damaged System
Problem
•System was dropped or damaged.
Action
CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. Before performing any procedure, see your Product Information Guide for complete information about safety precautions, working inside the computer and protecting against electrostatic discharge.
1Open the system. See "Opening and Closing the System" on page 54.
2Ensure that the following components are properly installed:
•Expansion cards and risers
•Power supplies
•Fans
•Processors and heat sinks
•Memory modules
•
3Ensure that all cables are properly connected.
4Close the system. See "Opening and Closing the System" on page 54.
5Run the system board tests in the system diagnostics. See "Running the System Diagnostics" on page 132.
If the tests fail, see "Getting Help" on page 147.
Troubleshooting Your System