Installing a SATA Hard Drive and Interposer Card Into a SATAu
NOTE: When you install a SATA hard drive into a SATAu drive carrier, you must install an interposer card onto the back of the hard drive. The SATAu drive carrier is labeled "SATAu" and also has marks indicating the SAS and SATA mounting screws.
1Insert the SATA hard drive into the SATAu
2Viewing the assembly as shown in Figure
When aligned correctly, the rear of the interposer will be flush with the rear of the
3Attach the four screws to secure the hard drive to the
4Attach the interposer card to the rear of the SATA hard drive:
a Angle the top of the interposer card into the inside top carrier rail so that the tabs on the interposer card bracket attach to the slots on the inside of the carrier rail. See Figure
b Rotate the bottom end of the card toward the hard drive to seat the connector. See Figure
c Push the bottom end of the card to the hard drive until the latch on the card bracket clicks into place.
Installing System Components
61