Table
Message | Causes | Corrective Actions |
|
|
|
Timer chip counter 2 | Faulty system board. | See "Getting Help" on page 147. |
failed |
|
|
Unsupported CPU | Microprocessor(s) is not supported by |
combination | the system. |
Unsupported CPU stepping |
|
detected |
|
Install a supported microprocessor or microprocessor combination. See "Processors" on page 93.
Utility partition not | The <F10> key was pressed during | Create a utility partition on the boot |
available | POST, but no utility partition exists | hard drive. See the CDs that came with |
| on the boot hard drive. | your system. |
|
|
|
Warning! No micro code | Micro code update failed. | Update the BIOS firmware. See "Getting |
update loaded for |
| Help" on page 147. |
processor 0 |
|
|
Warning: | Embedded RAID | Embedded RAID firmware does not |
firmware | is not present. | respond. |
See the RAID controller documentation for information about installing or updating the RAID firmware.
Warning: Embedded RAID | Embedded RAID firmware responds | See "Troubleshooting a SAS or SAS |
error. | with an error. | RAID Controller Daughter Card" on |
|
| page 126. See the RAID controller |
|
| documentation for information about |
|
| installing or updating the RAID |
|
| firmware. |
Warning: The current memory configuration is not optimal. Dell recommends a population of 2, 4, or 8 DIMMs. DIMMs should be populated sequentially starting in slot 1.
System has detected a legal but non- optimal population of DIMMs (for example, 1 DIMM, 6 DIMMs,
4 DIMMs in slots 1, 2, 5, and 6, etc.). The system will run with all memory accessible but will experience sub- optimal performance.
Populate 2, 4, or 8 DIMMs sequentially beginning with slot 1. See "System Memory" on page 89.
Write fault | Faulty diskette, optical/diskette drive | ||
Write | fault on selected | assembly, hard drive, or | |
subsystem. | |||
drive |
| ||
|
|
See "Troubleshooting a Diskette Drive" on page 121, "Troubleshooting an Optical Drive" on page 123, and "Troubleshooting a Hard Drive" on page 124.
NOTE: For the full name of an abbreviation or acronym used in this table, see the "Glossary" on page 169.
34