Datamax manual 4203/E-4204/E-4304

Page 22

6. Place the Ribbon Hubs back into the printer and route the ribbon through the printhead carrier assembly as shown below.

Note: Always make sure the ink side of the ribbon faces the media and NOT the printhead.

7. The ‘Media Type’ setting within the printer’s setup must be set to ‘Thermal Transfer’ to print using a ribbon. See Section 4.4.

12	E-4203/E-4204/E-4304

Image 22

Contents 4203 / E-4204 / E-4304 Page Firmware Software Agreement Part NumberAgency Compliance and Approvals Important Safety Instructions Page Printer Overview Label Alignment Troubleshooting Troubleshooting Page Introduction Direct Thermal ModelStandard Features About this PrinterOptional Features Thermal Transfer4203/E-4204/E-4304 Before using the Printer Removing the PackagingInspecting the Printer Additional RequirementsConnecting the Printer Power ConnectionInterface Connection Interface Cables Loading Media Loading Media for Peel Configuration Loading Ribbon Thermal Transfer 4203/E-4204/E-4304 Flash Memory Expansion 4203/E-4204/E-4304 Front Panel Operation LightsNormal Mode Button Functions ButtonsPrinter Setup Mode Button Functions Printer Setup Menu List Menu Items and Values Media Type Sensor TypeRange 0 15 default = *10 Internal Module Example of Changing Baud Rate 4203/E-4204/E-4304 New ‘19.2’ Value Label Alignment Label Alignment = YESLabel Alignment = Auto Label Alignment = noLabel Alignment Recommended Settings Label Stock Label Alignment SettingLabel Alignment Troubleshooting Problem Possible Solution DescriptionProblem Possible Solution Description Cause Fault LED Calibration Mode Media Sensor Calibration Procedure Auto Media Calibration Procedure Database Configuration and Dot Check Label Internal LabelsFaulty Test Label Good Test LabelTest Label To print the Test Label4203/E-4204/E-4304 Area Method Interval Cleaning the Printhead Media Width Adjustment Ribbon Width Adjustment Ribbon Ribbon Width Direction of RotationFine Printhead Adjustment Printhead Replacement RemovalDarkness Adjustment Resetting to the Factory DefaultsDownloading Firmware and Fonts Problem Situation Unacceptable print quality Skips every other label Label advances 1-2 inches before a fault indication Printer Specifications Printer SpecificationsMechanical Flash Memory Fonts Media/RibbonCommunications Imbedded Bar CodesApproved Media Designator Description4203/E-4204/E-4304 Ascii Control Code Chart XON Embedded Fonts and Barcodes Font Valid Ascii Characters decimal Use with RecordAlphanumeric, upper and lower Alphanumeric, uppercase Page Barcodes Bar Code Type Length Check Valid Ascii CharactersUPS Barcode H Health Industry Barcode K Plessey Barcode I CodabarBarcode O Code Barcode p Postnet Kmart NON EDI Barcode v FIM Bar Code W1c DataMatrix Barcode T TelepenBar Code W1f Aztec Datamax Barcode Products Limited Warranty Statement PrinterWarranty Service Procedures Thermal PrintheadGeneral Warranty Provisions Limitation of Liability4203/E-4204/E-4304