Datamax E-4304 manual Fault LED

Problem	Possible		Solution
Description	Cause
Tear Mode selected	Another present	Ø	Disable the Present Sensor.
but label stop	position has been		~OR~
position (present	determined.
		Ø	Ensure the host computer is not
position) is not far	Enabling the
enough forward.	Present Sensor		providing a Present Distance
	causes the label		shorter than is required for the
	stop position		Tear Bar.
	(present position)
	to be
	approximately
	0.1” behind the
	peel bar.
	~OR~
	The Present	Ø	Use the Menu Setup to modify
	Adjust value is
			the Present Adjust value.
	not correct.
Tear Mode selected	Another present	Ø	Ensure the host computer is not
but label stop	position has been		providing a Present Distance
position (present	determined.		longer than is required for the
position) is too far			Tear Bar.
forward.	~OR~
	The Present	Ø	Use the Menu Setup to modify
			the Present Adjust value.
	Adjust value is
	not correct.
FAULT LED	The label supply	Ø	Load new label stock
illuminates during	is empty
label alignment

30 E-4203/E-4204/E-4304