Datamax E-4304 manual Buttons, Normal Mode Button Functions

Page 26

4.2Buttons

Three buttons perform different functions based on the mode the printer is in. The printer operates in one of the following modes:

Normal: Normal printer functions (i.e. Pause, Feed, and Cancel). See Section 4.3

Printer Setup: Allows setting of the printer’s operating menu items (i.e. Media Settings, Communications, and Options. See Section 4.4

Calibration: Allows the printer to ‘calibrate’ the media for sensing of the Top of Form. See Section 4.6

4.3Normal Mode - Button Functions

In ‘Normal Mode’ the printer’s buttons control normal operations such as Pause, Feed, and Cancel as well as test and reset functions by using button combinations.

Button Combinations (push buttons simultaneously)

	+		Prints the Test Label, see section 4.7.2.
	+		Performs a warm reset and return to the Normal Mode of
			operation.
	+		Will cause the printer to print the Database
			Configuration and Dot Pattern Labels.

16	E-4203/E-4204/E-4304

Image 26

Contents 4203 / E-4204 / E-4304 Page Firmware Software Agreement Part NumberAgency Compliance and Approvals Important Safety Instructions Page Printer Overview Label Alignment Troubleshooting Troubleshooting Page Introduction Direct Thermal ModelStandard Features About this PrinterOptional Features Thermal Transfer4203/E-4204/E-4304 Before using the Printer Removing the PackagingInspecting the Printer Additional RequirementsConnecting the Printer Power ConnectionInterface Connection Interface CablesLoading Media Loading Media for Peel Configuration Loading Ribbon Thermal Transfer 4203/E-4204/E-4304 Flash Memory Expansion 4203/E-4204/E-4304 Front Panel Operation LightsNormal Mode Button Functions ButtonsPrinter Setup Mode Button Functions Printer Setup Menu List Menu Items and Values Media Type Sensor TypeRange 0 15 default = *10 Internal Module Example of Changing Baud Rate 4203/E-4204/E-4304 New ‘19.2’ Value Label Alignment Label Alignment = YESLabel Alignment = Auto Label Alignment = noLabel Alignment Recommended Settings Label Stock Label Alignment SettingLabel Alignment Troubleshooting Problem Possible Solution DescriptionProblem Possible Solution Description Cause Fault LED Calibration Mode Media Sensor Calibration Procedure Auto Media Calibration Procedure Database Configuration and Dot Check Label Internal LabelsFaulty Test Label Good Test LabelTest Label To print the Test Label4203/E-4204/E-4304 Area Method Interval Cleaning the Printhead Media Width Adjustment Ribbon Width Adjustment Ribbon Ribbon Width Direction of RotationFine Printhead Adjustment Printhead Replacement RemovalDarkness Adjustment Resetting to the Factory DefaultsDownloading Firmware and Fonts Problem Situation Unacceptable print quality Skips every other label Label advances 1-2 inches before a fault indication Mechanical Printer SpecificationsPrinter Specifications Flash Memory Fonts Media/RibbonCommunications Imbedded Bar CodesApproved Media Designator Description4203/E-4204/E-4304 Ascii Control Code Chart XON Embedded Fonts and Barcodes Font Valid Ascii Characters decimal Use with RecordAlphanumeric, upper and lower Alphanumeric, uppercase Page Barcodes Bar Code Type Length Check Valid Ascii CharactersUPS Barcode H Health Industry Barcode O Code Barcode p Postnet Barcode I CodabarBarcode K Plessey Kmart NON EDI Bar Code W1f Aztec Barcode T TelepenBarcode v FIM Bar Code W1c DataMatrix Datamax Barcode Products Limited Warranty Statement PrinterWarranty Service Procedures Thermal PrintheadGeneral Warranty Provisions Limitation of Liability4203/E-4204/E-4304