Datamax E-4304 manual Flash Memory Expansion

Page 23

3.4Flash Memory Expansion

The printer can be equipped with an optional Flash Memory Expansion. This flash expansion can be used for storage of label formats and fonts. For font downloading instructions refer to Section 5.8 in this manual.

To install the Flash Memory Expansion:

ŒTurn the power off and unplug the printer.

Remove any installed media from the printer.

• Using a coin, flathead screwdriver, or similar object, insert it into the Slot on the underside of the printer and gently pry the Expansion Cover off the printer.

Ž With the Flash Memory

Expansion Assembly oriented as shown (connector down), gently insert it into the Expansion Bay until the assembly is firmly seated.

Note: When using a blank expansion module for the first time the printer will automatically format it when the printer is powered up. This initial format can take up to one minute.

E-4203/E-4204/E-4304

13

Image 23

Contents 4203 / E-4204 / E-4304 Page Part Number Firmware Software AgreementAgency Compliance and Approvals Important Safety Instructions Page Printer Overview Label Alignment Troubleshooting Troubleshooting Page Direct Thermal Model IntroductionAbout this Printer Standard FeaturesThermal Transfer Optional Features4203/E-4204/E-4304 Removing the Packaging Before using the PrinterAdditional Requirements Inspecting the PrinterPower Connection Connecting the PrinterInterface Cables Interface ConnectionLoading Media Loading Media for Peel Configuration Loading Ribbon Thermal Transfer 4203/E-4204/E-4304 Flash Memory Expansion 4203/E-4204/E-4304 Lights Front Panel OperationButtons Normal Mode Button FunctionsPrinter Setup Mode Button Functions Printer Setup Menu List Media Type Sensor Type Menu Items and ValuesRange 0 15 default = *10 Internal Module Example of Changing Baud Rate 4203/E-4204/E-4304 New ‘19.2’ Value Label Alignment = YES Label AlignmentLabel Alignment = no Label Alignment = AutoLabel Stock Label Alignment Setting Label Alignment Recommended SettingsProblem Possible Solution Description Label Alignment TroubleshootingProblem Possible Solution Description Cause Fault LED Calibration Mode Media Sensor Calibration Procedure Auto Media Calibration Procedure Internal Labels Database Configuration and Dot Check LabelGood Test Label Faulty Test LabelTo print the Test Label Test Label4203/E-4204/E-4304 Area Method Interval Cleaning the Printhead Media Width Adjustment Ribbon Ribbon Width Direction of Rotation Ribbon Width AdjustmentFine Printhead Adjustment Removal Printhead ReplacementResetting to the Factory Defaults Darkness AdjustmentDownloading Firmware and Fonts Problem Situation Unacceptable print quality Skips every other label Label advances 1-2 inches before a fault indication Mechanical Printer SpecificationsPrinter Specifications Flash Memory Imbedded Bar Codes Media/RibbonCommunications FontsDesignator Description Approved Media4203/E-4204/E-4304 Ascii Control Code Chart XON Font Valid Ascii Characters decimal Use with Record Embedded Fonts and BarcodesAlphanumeric, upper and lower Alphanumeric, uppercase Page Bar Code Type Length Check Valid Ascii Characters BarcodesUPS Barcode H Health Industry Barcode O Code Barcode p Postnet Barcode I CodabarBarcode K Plessey Kmart NON EDI Bar Code W1f Aztec Barcode T TelepenBarcode v FIM Bar Code W1c DataMatrix Printer Datamax Barcode Products Limited Warranty StatementThermal Printhead Warranty Service ProceduresLimitation of Liability General Warranty Provisions4203/E-4204/E-4304