Datamax E-4304 manual Menu Items and Values, Media Type Sensor Type

4.4.2 Menu Items and Values

The table below lists all the menu items and their possible values in the ‘Printer Setup Procedure’.

1) MEDIA TYPE	2) SENSOR TYPE
Sets printing for either direct	Select the sensor type that matches your
thermal (no ribbon) or thermal	label stock.
transfer (ribbon) stock.	Possible Values:
Possible Values:
	* EDGE: (Gaps in media)
* DIRECT THERMAL
	(REFL) REFLECTIVE: (Black Mark)
THERMAL TRANSFER
	(CONT) CONTINUOUS: (No sensing)
3) PRESENT SENSOR	4) CUTTER EQUIPPED
Enables/Disables the optional	Enables/Disables the optional Cutter
Present Sensor Assembly	Assembly
Possible Values:	Possible Values:
* NO	* NO
YES	YES
5) SOP ADJUST	6) PRESENT ADJUST
This sets the point to begin printing,	This command specifies an additional
relative to the top-of-form (label’s	amount to advance the label after print.
edge as detected by the media	Possible Values:
sensor).
Possible Values:	Range: 0 – 255; default = *128
	0 = close to edge
Range: 0 – 255; default = *128
	255 = furthest from edge
0 = close to edge
255 = furthest from edge
7) BAUD RATE	8) DATA BITS
Sets serial port baud rate to match	Set data word length to match host.
host.	Possible Values:
Possible Values:
	* 8
600 to 38.4k; default = *9600	7

E-4203/E-4204/E-4304 19