ENGLISH
2 CONNECTIONS
CONNECTIONS
1.Turn off the POWER switch.
2.Connect the RCA pin cords to the inputs on your mixer.
COUTION:
•Be sure to use the supplied control cord. Using another type of cable may result in damage.
•Be sure the power is off when connecting the control cord. Otherwise the units may not work properly.
Connection to a PC
•The
This means that when the
•To connect the
•When connected, the display below appears at the bottom right of the PC’s screen.
RCA Cord | CH4 Input jack | CH6 Input jack |
3.5 mm stereo mini cord | CH4 Fader jack | CH6 Fader jack |
CH2 Input jack |
|
RCA Cord
CH2 Fader jack
3.5 mm stereo mini cord
BU4500
Drive1 Fader jack 
Drive1 Output jack
DN-HC4500
Deck1
Fader jack
Deck1 Output jack
RCA Cord
3.5mm stereo mini cord
CH8 Input jack
RCA Cord
CH8 Fader jack
3.5mm stereo mini cord
Drive2 Fader jack
Drive2 Output jack
DRIVE terminal
Deck2
Fader jack
Deck2 Output jack
USB B terminal
Found New Hardware
USB audio device
Once installation is completed, the message “Your new hardware is installed and ready to use.” is displayed, as shown below.
Found New Hardware
Your new hardware is installed and ready to use.
Installation is now complete. The
Connection to a Macintosh computer
• The |
the Macintosh OS, and is immediately ready for |
use when connected. |
• To connect the |
computer via a usable USB port, use the included |
USB cable. |
Some features will not work for
DENON PC/MAC Upgrade Application and ASIO Driver Application included.
Computer OS versions that can be connected to the
Mac OSX 10.4 or later
Computers with other operating systems are not compatible with USB MIDI, so the computer may operate erratically after connected to the DN- HC4500 by USB.
2
ENGLISH