Denon DN-HC4500 manual Part Names and Function, Side Panel, Front panel

3PART NAMES AND FUNCTION

(1)Side Panel

u y

q w e r t

ENGLISH

(2) Front panel

#3#2#1 #0 @9@8@7@6@5@4

i	!0 !2 !4!6!8!9	@0@1	@2	@3
o	!1 !3 !5!7

CAUTION:

Note that there are many buttons working two different function selected by short time pushing or long pushing (1second or more). The “ ” mark indicates short time push function and “ ” mark indicates long time push function.

qAnalog out put terminal (LINE OUT)

•This is unbalanced RCA output terminals.

•Audio signals outputs.

wDRIVE terminal

•Connect the DN-D4000/D4500/BU4500 drive unit.

For instructions on operating the DN-D4000/ D4500/BU4500, refer to the respective model’s operating instructions.

rPOWER button

• Push this button to turn power on and off.

tAC Inlet terminal

•Inlet the power cord’s plug into DN-HC4500’s AC inlet terminal.

yFader start terminals

•Use this when your mixer has the Fader Start function.

i TIME, Total

[When PCDJ connected]

Refer to the PCDJ’s manual.

[When DN-D4500 connected]

• TIME:

When this button is pressed, the time

indicator switches between “ELAPSED”

(elapsed time), “REMAIN” (remaining time).

• Total:

!0 MEMO, PRESET

[When PCDJ connected]

Refer to the PCDJ’s manual.

[When DN-D4500 connected]

• MEMO:

The MEMO mode starts when this button is

pushed once in the Cue/Pause mode.

• PRESET:

When this button is pushed for more than 1

e USB B terminal	u X-CONROL output terminal
• Connect to a computer.	• Use this when connected to a DENON DN-
• Sends the USB MIDI and HID commands	X900 or DN-X500 mixer that offers X-Control.
from the DN-HC4500.	• With the DN-HC4500 it is possible to convert
• Sends the USB audio signals from a PC.	the input fader position into a MIDI signal and
	send it from the USB terminal.

When this button is pushed for more 1

second, you can display the total time.

oFLIP/B TRIM

[When PCDJ connected] Refer to the PCDJ’s manual.

[When DN-D4500 connected]

•Push this button to switch between the loop mode/hot start mode and stutter mode.

•After setting the B point, the B TRIM MODE can be selected.

sec, the PRESET mode menu is displayed.

!1CUE/STUTTER

[When PCDJ connected], [When DN-D4500 connected]

•Pushing this button in play mode will force the file back to the position which playback started.

•In Cue mode, by pushing the CUE button makes a Stutter sound from the Cue point. This is called Stutter play. (Stutter)

3

ENGLISH