Hand Held Products 3700 CCD manual Serial Commands Summary, Command Format

SERIAL COMMANDS SUMMARY

C

C.1 Configuration Commands

The following is a summary of configuration commands sent by the host system. More details are provided in Section 4.4, Configuration Commands.

Note: These commands may contain port–specific data not relevant to the SCANTEAM 3700 machine mount CCD. This extra data will be accepted, but ignored. These items are identified in the command descriptions by a pound sign (#).

Command	Format
Set Communications Port Command	<Ka baud, parity, stop bits, data bits>
Set Preamble Command	<Kd enable, data>
Set Postamble Command	<Ke enable, data>
Set Communications Protocol Command	<Kf mode>
Set Trigger Mode Command	<Kg mode_global, mode_port_1,
	mode_port_2, #>
Set Read Timeout Command	<Kh mode_global, time_global,
	mode_port_1, time_port_1,
	mode_port_2, time_port_2, #, #>
Set No Read Message Command	<Kk enable, data>
Set Votes Command	<Km data_global, data_port_1,
	data_port_2, #>
Set Code 39 Command	<Kp enable, require checksum, send
	checksum, minimum length,
	maximum length>
Set Codabar Command	<Kq enable, send start/stop, minimum
	length, maximum length>
Set I 2 of 5 Command	<Kr enable, require checksum, send
	checksum, minimum length,
	maximum length>
Set UPC A/E, EAN 8/13	<Ks enable UPC, enable EAN>
Set Code 128 Command	<Kt enable, minimum length,
	maximum length>
Set Beeper Mode	<Ku mode_global, mode_port_1,
	mode_port_2, #>

Serial Commands Summary C–1