Monarch 9401, 9402 manual Slide the supply guide to the top of the supply guide roller

Page 19

4. Loading Supplies

8.Slide the supply guide to the top of the supply guide roller.

	Front of	Supply
	Printer	Supply	Printhead
	Printer	Guide
		Guide
	Supply
	Sensor

Supply

Guide

Roller

9.Remove the seal from the new supply roll.

10.Remove the first label from the backing paper.

11.Place the supply roll on the supply platter.

12.Feed the supply through the supply sensor, past the printhead, and out the front of the printer.

13.Remove the labels from the first 10 inches (254 mm) of backing paper.

15

Image 19

Contents Equipment Manual Canadian D.O.C. Warning Table of Contents 9401/9402 Equipment Manual Introduction What action you should take Installing the Printer 9401/9402 Equipment Manual On the Keypad Using the KeysOn the Computer Keyboard − in one strip see Continuous Printing Loading SuppliesSupply Loading Diagram Continuous Printing Backing Paper Take-up Reel Wire Clip Feed Supply On-Demand Printing Tear backing paper here Backing Paper Take-up Reel Slide the supply guide to the top of the supply guide roller Loop the backing paper back through the platen unit as shown Printhead SupplyLever Guide 9401/9402 Equipment Manual Loading the Ribbon Remove the old ribbon by pulling the wire clips as shown Core Ribbon Take-up Reel Cleaning the Printhead and Platen Roller Lightly moisten a cotton swab with rubbing alcohol Replacing the Fuse 9401/9402 Equipment Manual Problem Corrective Action TroubleshootingProblem Corrective Action Troubleshooting 9401/9402 Equipment Manual Printer SpecificationsSupplies Page U.S.A Canada