Monarch 9401, 9402 manual Cleaning the Printhead and Platen Roller

Page 27

6.Cleaning the Printhead and Platen Roller

WARNING

Turn the power Off and unplug the cord before cleaning.

1.Open the cover by lifting the handle and pulling it completely around the top of the printer.

2.Move the printhead lever as shown to open the printhead.

Printhead

Lever

Handle

3.Wind the supplies back onto the supply roll. If backing paper is rewound on the backing paper take-up reel, tear it as described in "Loading Supplies."

4.Remove the ribbon, if one is loaded. See "Loading the Ribbon" in this manual.

23

Image 27

Contents Equipment Manual Canadian D.O.C. Warning Table of Contents 9401/9402 Equipment Manual Introduction What action you should take Installing the Printer 9401/9402 Equipment Manual On the Keypad Using the KeysOn the Computer Keyboard − in one strip see Continuous Printing Loading SuppliesSupply Loading Diagram Continuous Printing Backing Paper Take-up Reel Wire Clip Feed Supply On-Demand Printing Tear backing paper here Backing Paper Take-up Reel Slide the supply guide to the top of the supply guide roller Loop the backing paper back through the platen unit as shown Printhead SupplyLever Guide 9401/9402 Equipment Manual Loading the Ribbon Remove the old ribbon by pulling the wire clips as shown Core Ribbon Take-up Reel Cleaning the Printhead and Platen Roller Lightly moisten a cotton swab with rubbing alcohol Replacing the Fuse 9401/9402 Equipment Manual Problem Corrective Action TroubleshootingProblem Corrective Action Troubleshooting 9401/9402 Equipment Manual Printer SpecificationsSupplies Page U.S.A Canada