Monarch 9401, 9402 manual Replacing the Fuse

Page 29

7. Replacing the Fuse

CAUTION

As a safety measure, be sure to turn the printer Off and unplug the power cord.

1.Turn the printer Off and unplug the power cord.

Power Switch

Fuse Cover

Facing the back of the printer, press and turn the fuse cover as shown until it pops out.

3.Pull the fuse out of the cover.

4.Insert a 1.5 amp, 250V slow blow fuse into the fuse cover and push until the fuse is fully seated.

25

Image 29

Contents Equipment Manual Canadian D.O.C. Warning Table of Contents 9401/9402 Equipment Manual Introduction What action you should take Installing the Printer 9401/9402 Equipment Manual On the Keypad Using the KeysOn the Computer Keyboard − in one strip see Continuous Printing Loading SuppliesSupply Loading Diagram Continuous Printing Backing Paper Take-up Reel Wire Clip Feed Supply On-Demand Printing Tear backing paper here Backing Paper Take-up Reel Slide the supply guide to the top of the supply guide roller Loop the backing paper back through the platen unit as shown Printhead SupplyLever Guide 9401/9402 Equipment Manual Loading the Ribbon Remove the old ribbon by pulling the wire clips as shown Core Ribbon Take-up Reel Cleaning the Printhead and Platen Roller Lightly moisten a cotton swab with rubbing alcohol Replacing the Fuse 9401/9402 Equipment Manual Problem Corrective Action TroubleshootingProblem Corrective Action Troubleshooting 9401/9402 Equipment Manual Printer SpecificationsSupplies Page U.S.A Canada