Monarch 9401, 9402 manual Installing the Printer

Page 7

2. Installing the Printer

1.Place the printer on a level surface.

Power

Cord

				Power
				Switch
RS-232				Switch
RS-232		Keyboard
Cable		Connector
Cable		Connector

CAUTION

The power switch must be Off while you connect any cables to the printer.

2.If you are going to use the printer on-line, connect the RS-232 (on-line) cable as shown.

3.If you are going to use the optional Monarch computer keyboard, remove the keyboard from its separate shipping carton. Then, remove the plastic cap from the end of the keyboard cable and connect it to the keyboard connector on the printer.

3

Image 7

Contents Equipment Manual Canadian D.O.C. Warning Table of Contents 9401/9402 Equipment Manual Introduction What action you should take Installing the Printer 9401/9402 Equipment Manual On the Keypad Using the KeysOn the Computer Keyboard − in one strip see Continuous Printing Loading SuppliesSupply Loading Diagram Continuous Printing Backing Paper Take-up Reel Wire Clip Feed Supply On-Demand Printing Tear backing paper here Backing Paper Take-up Reel Slide the supply guide to the top of the supply guide roller Loop the backing paper back through the platen unit as shown Printhead SupplyLever Guide 9401/9402 Equipment Manual Loading the Ribbon Remove the old ribbon by pulling the wire clips as shown Core Ribbon Take-up Reel Cleaning the Printhead and Platen Roller Lightly moisten a cotton swab with rubbing alcohol Replacing the Fuse 9401/9402 Equipment Manual Problem Corrective Action TroubleshootingProblem Corrective Action Troubleshooting 9401/9402 Equipment Manual Printer SpecificationsSupplies Page U.S.A Canada