Monarch 9402, 9401 manual Lightly moisten a cotton swab with rubbing alcohol

Page 28

9401/9402 Equipment Manual

5.Lightly moisten a cotton swab with rubbing alcohol.

Printhead

Platen

Roller

6.Rub the swab up and down the printhead as shown. Clean the platen roller the same way.

7.Re-load the supply roll and ribbon, if necessary.

8.Close the printhead.

9.Close the printer cover.

10.Turn the power On.

11.If printing is not improved, call Service toll free at the number on the back cover of this manual.

24

Image 28

Contents Equipment Manual Canadian D.O.C. Warning Table of Contents 9401/9402 Equipment Manual Introduction What action you should take Installing the Printer 9401/9402 Equipment Manual Using the Keys On the KeypadOn the Computer Keyboard Loading Supplies − in one strip see Continuous PrintingSupply Loading Diagram Continuous Printing Backing Paper Take-up Reel Wire Clip Feed Supply On-Demand Printing Tear backing paper here Backing Paper Take-up Reel Slide the supply guide to the top of the supply guide roller Loop the backing paper back through the platen unit as shown Printhead SupplyLever Guide 9401/9402 Equipment Manual Loading the Ribbon Remove the old ribbon by pulling the wire clips as shown Core Ribbon Take-up Reel Cleaning the Printhead and Platen Roller Lightly moisten a cotton swab with rubbing alcohol Replacing the Fuse 9401/9402 Equipment Manual Troubleshooting Problem Corrective ActionProblem Corrective Action Troubleshooting 9401/9402 Equipment Manual Specifications PrinterSupplies Page U.S.A Canada