Matsushita CF-19FHGAX service manual Setting up the Inverter Assy and LCD Unit, Sheet, PCB Spacer

9.2.Reassembly Instructions

9.2.1.Attention when CF-19 series is repaired

ïPlease execute writing BIOS ID when you exchange the Main Board.

ïParts (Sheet and rubber) etc. related various the Conductive Cloth and Heat Spreader cannot be recycled. Use new parts.

9.2.2.Setting up the Inverter Ass'y and LCD UNIT

1.	Set the LCD UNIT to the LCD Front Cabinet/TS Panel.
2.	Set the TS PCB on the LCD Back Damper, and connect		Tape
	the 2 Cables to the Connectors (CN900 and CN901).
3.	Set the Inverter PCB to the LCD Back Damper, and con-		Connector
	nect the 2 Cables to the Connectors.
		Inverter Case	Inverter PCB

Connector

Connector

(CN901)

TS PCB

Connector (CN900)

LCD Unit

■Assembly of LCD Back Damper (Applicable Model : Touch Screen Model)

Detail of "B"

01mm

Pass the Cable 0 0.5mm under the protrusion.

Detail of "C"

01mm

Pass the Cable

through the space.11.5mm

Detail of "D"

0	1mm
	0	0.5mm
Pass the Cable
under the protrusion.

	LCD Back Cushion S	LCD Back Cushion L	LCD Back Cushion S
Note: Apply the load to attach. 20 to 30N (2.0 to 3.0 Kgf)	B	C	D

Order of fixing	33	35mm
	Detail of "A"
	2 4mm	A		Remove the Release Paper on
			Holder Sheet	the back side and attach it.
				Lengthwise : Match to the LCD Frame.		Holder Sheet
				Crosswise : Match to the middle line.
	LCD Side Cushion A
	Attach to the side surface if the Frame.
	(Match to the end of the Frame within		Match both Holder Sheet and LCD		Match both Holder Sheet and LCD
	0 to 0.5 mm at the far side.)		Back Cushion S to the right edge
					Back Cushion S to the right edge
			of the frame. (0 to 0.5 mm)
					of the frame. (0 to 0.5 mm)
	LCD PWB Spacer Ass'y
	Insert this between LCD
	PCB & LCD Frame.
	Screw 1
	Screw the board and
	the Spacer together.

00.5mm

Screw 2

Screw the board and the Spacer together.

						LCD Side Cushion C	LCD Side Cushion D	LCD Side Cushion C
LCD PWB SPACER ASSY						0 0.5mm
				Spacer	Sheet		0.5mm	0.5mm
Spacer	Sheet
		LCD	PCB Spacer
			Asymmetric Shape			0.5mm		0.5mm
							0.5mm

31 / 90