Ositech comm Trumpcard Data/Fax Modem Set Pulse Dial as Default, Qn Result Code Display, ATQ0

Section Four

Result Codes

CONNECT XXXX If a connection is established

NO CARRIER If retrain is not successful in the time specified by S7

P — Set Pulse Dial as Default

Parameters none

Defaultnone

Causes the modem to assume that all subsequent dial commands are pulse dialled. The user may omit the "P" from the dial strings.

Qn — Result Code Display

Parameter 0 or 1

Default0

Determines whether or not the modem returns the result codes (see Xn command).

Examples

ATQ0	Allows the modem to return result codes
ATQ1	Prohibits the modem from returning result codes
Sn — Read/Write S Registers
Parameters	n = 0-95 x = 0-255
Default	none

Selects a S register, reads or writes the contents of a S register, or reports the value of a S register. All the S registers may be read. If no parameter is entered, S0 is assumed. The “S” can be omitted to assume the last S- register accessed.

All the registers will return the OK response if x is a legal value; however, some registers will not actually write the value anywhere.

If the parameter number is beyond the range of the S-registers available, the modem will return the ERROR message. The value x is “MOD”ed with 256, and if the result is outside the range permitted for a given S-register, the values will still be stored, but functionally, the lower and higher limits will be observed. Input and output is always in decimal format. Note that some S-registers are read-only.

In some cases, writing to the S-register will appear to be accepted but the value will not actually be written.

4 - 14 Trumpcard 14400/28800 Modem