Ositech comm Trumpcard Data/Fax Modem manual Modem S Registers, Modem Register Summary

Section Four

The above command processes the &F&C1&D2&S1 once when the command line is first entered, the S95=18 whenever operating as a land based connection and S95=44)M1*H2:E0 whenever operating as a cellular based connection.

AT[] or AT[0]

The above command clears any command(s) associated with event 0 (land based connection).

Modem S Registers

The S registers are summarized below along with their default values. Registers denoted with an * may be stored in one of the two user profiles by entering the &Wn command. One of these profiles may be loaded at any time by using the Zn command.

Default Register Settings

The factory default values are stored in ROM and are loaded into the active configuration at power up or by the Zn command. In addition, the designated default profile is subsequently loaded, and may change some of the factory default values. The designated default profile can be changed by entering the &Yn command where n is one of the two possible user profiles. All of the factory default values may be loaded at any time by entering the &F command.

Modem Register Summary

Register		Title	Default
S0	*	Number of Rings Till Auto-Answer	0
S1		Ring Counter	0
S2	*	Escape Character	43
S3		Carriage Return Character	13
S4		Line Feed Character	10
S5		Back Space Character	8
S6		Wait For Blind Dialling *	2
S7	*	Wait For Carrier After Dial	50
S8	*	Pause Time For Dial Delay	2

4 - 34 Trumpcard 14400/28800 Modem