Software Management
RF Monitor is a very small program and does not even require installation. Just place it in a directory on your PC and create a shortcut to run it. It will run on all versions of Windows except V3.1 and Windows 95.
1.Move RF Monitor to a Windows PC with Network access to the RF terminal.
2.Run RF Monitor. (Create a shortcut or do a Start/Run.)
3.From the pull down menu, select File/Select Terminal.
4.Key in the RF terminal IP address and leave the port at 1802.
5.From the pull down menu, select Tools/Set Debug Levels. Set all levels to 9 except Datastream and SNA.
Supported Equipment Manual • May, 2006 |