The Speaker Company TTP-343C, TTP-245C Setting Ethernet by Diagnostic Utility, Later versions

Page 26

3.6 Setting Ethernet by Diagnostic Utility

The Diagnostic Utility is enclosed in the CD disk \Utilities directory. Users can use Diagnostic Tool to setup the Ethernet by RS-232, USB and Ethernet interfaces. The following contents will instruct users how to configure the Ethernet by these three interfaces.

3.6.1Using USB interface to setup Ethernet interface

1.Connect the USB cable between the computer and the printer.

2.Turn on the printer power.

3.Start the Diagnostic Utility by double clicking on the icon.

Note: This utility works with printer firmware	V6.00 and
later versions.

4.The Diagnostic Utility default interface setting is USB interface. If USB interface is connected with printer, no other settings need to be changed in the interface field.

5.Click on the “Ethernet Setup” button from “Printer Function” group in Printer Configuration tab to setup the IP address, subnet mask and gateway for the on board Ethernet.

20

Image 26

Contents TTP-245C / TTP-343C / TTP-244CE Contents Mark Sensor Copyright Declaration Introduction Product IntroductionIii Operations Overview Unpacking and InspectionPrinter Overview V1.0 MicroSD 512 MB Panasonic Transcend, Panasonic Interior view Rear View Setup Setting up the PrinterOpen / Close the Top Cover Loading the Ribbon Please refer to videos on TSC YouTube or driver CD  Loading Path for Ribbon Loading the Media  Loading path for roll labels External Label Roll Mount Installation Option Page Push the peel-off panel back to the printer Page Loading Media in Cutter Mode Option Diagnostic Tool Function Description Setting Ethernet by Diagnostic Utility Later versionsUsing RS-232 interface to setup Ethernet interface Using Ethernet interface to setup Ethernet interface Page Install SD Memory Card V1.0 MicroSD 256 Transcend, Panasonic 512 LED and Button Functions LED indicatorPower on utilities Regular button functionFunctions 2 Gap/Black Mark Calibration, Self-test and Dump Mode Self-test Gap/black mark sensor intension  Dump mode Parameter Default setting Set Gap Sensor as Media Sensor and Calibrate the Gap SensorSkip AUTO.BAS Troubleshooting LED StatusProblem Possible Cause Recovery Procedure Print QualityMaintenance Printer Part Method IntervalPage Date Content Editor Revise HistoryNo.35, Sec , Ligong 1st Rd., Wujie Township