The Speaker Company TTP-343C LED and Button Functions, LED indicator, Regular button function

Page 32

4. LED and Button Functions

This printer has one button and one three-color LED indicator. By indicating the LED with different color and pressing the button, printer can feed labels, pause the printing job, select and calibrate the media sensor, print printer self-test report, reset printer to defaults (initialization). Please refer to the button operation below for different functions.

4.1 LED indicator

LED Color

Description

Green/ Solid

This illuminates that the power is on and the device is ready to

 

use.

 

 

Green/ Flash

This illuminates that the system is downloading data from PC to

 

memory or the printer is paused.

 

 

Amber

This illuminates that the system is clearing data from printer.

 

 

Red / Solid

This illuminates printer head open, cutter error.

 

 

Red / Flash

This illuminates a printing error, such as head open, paper

 

empty, paper jam, ribbon empty, or memory error etc.

 

 

4.2 Regular button function

1. Feed labels

When the printer is ready, press the button to feed one label to the beginning of next label.

2. Pause the printing job

When the printer is printing, press the button to pause a print job. When the printer is paused the LED will blink green. Press the button again to continue the printing job.

4.3 Power on utilities

There are six power-on utilities to set up and test printer hardware. These utilities are activated by pressing FEED button then turning on the printer power simultaneously and release the button at different color of LED.

Please follow the steps below for different power-on utilities.

1.Turn off the power switch.

2.Hold on the button then turn on the power switch.

26

Image 32
Contents TTP-245C / TTP-343C / TTP-244CE Contents Mark Sensor Copyright Declaration Introduction Product IntroductionIii Operations Overview Unpacking and InspectionPrinter Overview V1.0 MicroSD 512 MB Panasonic Transcend, Panasonic Interior view Rear View Setup Setting up the PrinterOpen / Close the Top Cover Loading the Ribbon Please refer to videos on TSC YouTube or driver CD  Loading Path for Ribbon Loading the Media  Loading path for roll labels External Label Roll Mount Installation Option Page Push the peel-off panel back to the printer Page Loading Media in Cutter Mode Option Diagnostic Tool Function Description Setting Ethernet by Diagnostic Utility Later versionsUsing RS-232 interface to setup Ethernet interface Using Ethernet interface to setup Ethernet interface Page Install SD Memory Card V1.0 MicroSD 256 Transcend, Panasonic 512 LED indicator Power on utilitiesLED and Button Functions Regular button functionFunctions 2 Gap/Black Mark Calibration, Self-test and Dump Mode Self-test Gap/black mark sensor intension  Dump mode Parameter Default setting Set Gap Sensor as Media Sensor and Calibrate the Gap SensorSkip AUTO.BAS Troubleshooting LED StatusProblem Possible Cause Recovery Procedure Print QualityMaintenance Printer Part Method IntervalPage Date Content Editor Revise HistoryNo.35, Sec , Ligong 1st Rd., Wujie Township