The Speaker Company TTP-245C, TTP-244CE, TTP-343C user manual Skip AUTO.BAS

Page 39

red/amber will do during the 5 blinks).

The LED color will be changed as following:

Amber red (5 blinks) amber (5 blinks) green (5 blinks) green/amber (5 blinks) red/amber (5 blinks) solid green

4.3.6Skip AUTO.BAS

TSPL2 programming language allows user to download an auto execution file to flash memory. Printer will run the AUTO.BAS program immediately when turning on printer power. The AUTO.BAS program can be interrupted without running the program by the power-on utility.

Please follow the procedures below to skip an AUTO.BAS program.

1.Turn off printer power.

2.Press the FEED button and then turn on power.

3.Release the FEED button when LED becomes solid green. The LED color will be changed as following:

Amber red (5 blinks) amber (5 blinks) green (5 blinks) green/amber (5 blinks) red/amber (5 blinks) solid green

4.Printer will be interrupted to run the AUTO.BAS program.

33

Image 39
Contents TTP-245C / TTP-343C / TTP-244CE Contents Mark Sensor Copyright Declaration Product Introduction IntroductionIii Unpacking and Inspection Operations OverviewPrinter Overview V1.0 MicroSD 512 MB Panasonic Transcend, Panasonic Interior view Rear View Setting up the Printer SetupOpen / Close the Top Cover Loading the Ribbon Please refer to videos on TSC YouTube or driver CD  Loading Path for Ribbon Loading the Media  Loading path for roll labels External Label Roll Mount Installation Option Page Push the peel-off panel back to the printer Page Loading Media in Cutter Mode Option Diagnostic Tool Function Description Later versions Setting Ethernet by Diagnostic UtilityUsing RS-232 interface to setup Ethernet interface Using Ethernet interface to setup Ethernet interface Page Install SD Memory Card V1.0 MicroSD 256 Transcend, Panasonic 512 Regular button function LED indicatorPower on utilities LED and Button FunctionsFunctions 2 Gap/Black Mark Calibration, Self-test and Dump Mode Self-test Gap/black mark sensor intension  Dump mode Set Gap Sensor as Media Sensor and Calibrate the Gap Sensor Parameter Default settingSkip AUTO.BAS LED Status TroubleshootingPrint Quality Problem Possible Cause Recovery ProcedurePrinter Part Method Interval MaintenancePage Revise History Date Content EditorNo.35, Sec , Ligong 1st Rd., Wujie Township