The Speaker Company TTP-245C, TTP-244CE, TTP-343C user manual Iii

Page 6

WARNUNG!

GEFÄ HRLICHE BEWEGLICHE TEILE – FINGER UND ANDERE KÖ RPERTEILE FERNHALTEN!

VORSICHT!

EXPLOSIONSGEFAHR BEI ERSATZ DER

BATTERIE DURCH UNZULÄ SSIGEN TYP.

VERBRAUCHTE BATTERIEN IMMER

VORSCHRIFTSGEMÄ SS ENTSORGEN!

B급기기

(가정용 정보통신기기)

이 기기는 가정용으로 전자파 적합등록을 한 기기로서 주거지역에서는 물론 모든 지역에서 사용할 수 있습니다.

Note

*Continuous printing will cause printer motor overheat. Printer will stop printing automatically about 10~15 minutes until motor is cooling down. Please don’t turn off power when printer pauses or the data transferred to printer buffer will be lost.

*The maximum printing ratio per dot line is 15% for this printer. To print the full web black line, the maximum black line height is limited to 40 dots, which is 5mm for 203 DPI resolution printer and 3.3mm for 300 DPI resolution printers.

*The max. full web black bar is limited to 5 mm only, otherwise this may damage the power supply.

iii

Image 6
Contents TTP-245C / TTP-343C / TTP-244CE Contents Mark Sensor Copyright Declaration Introduction Product IntroductionIii Operations Overview Unpacking and InspectionPrinter Overview V1.0 MicroSD 512 MB Panasonic Transcend, Panasonic Interior view Rear View Setup Setting up the PrinterOpen / Close the Top Cover Loading the Ribbon Please refer to videos on TSC YouTube or driver CD  Loading Path for Ribbon Loading the Media  Loading path for roll labels External Label Roll Mount Installation Option Page Push the peel-off panel back to the printer Page Loading Media in Cutter Mode Option Diagnostic Tool Function Description Setting Ethernet by Diagnostic Utility Later versionsUsing RS-232 interface to setup Ethernet interface Using Ethernet interface to setup Ethernet interface Page Install SD Memory Card V1.0 MicroSD 256 Transcend, Panasonic 512 LED and Button Functions LED indicatorPower on utilities Regular button functionFunctions 2 Gap/Black Mark Calibration, Self-test and Dump Mode Self-test Gap/black mark sensor intension  Dump mode Parameter Default setting Set Gap Sensor as Media Sensor and Calibrate the Gap SensorSkip AUTO.BAS Troubleshooting LED StatusProblem Possible Cause Recovery Procedure Print QualityMaintenance Printer Part Method IntervalPage Date Content Editor Revise HistoryNo.35, Sec , Ligong 1st Rd., Wujie Township