Printer configuration will be restored to defaults as below after initialization.
Parameter | Default setting |
Speed | 127 mm/sec (5 ips) (203DPI) |
| 76 mm/sec (3 ips) (300DPI) |
|
|
Density | 8 |
|
|
Label Width | 4” (101.5 mm) |
|
|
Label Height | 4” (101.5 mm) |
|
|
Sensor Type | Gap sensor |
|
|
Gap Setting | 0.12” (3.0 mm) |
|
|
Print Direction | 0 |
|
|
Reference Point | 0,0 (upper left corner) |
|
|
Offset | 0 |
|
|
Tear Mode | On |
|
|
Peel off Mode | Off |
|
|
Cutter Mode | Off |
|
|
Serial Port Settings | 9600 bps, none parity, 8 data bits, 1 stop bit |
|
|
Code Page | 850 |
|
|
Country Code | 001 |
|
|
Clear Flash Memory | No |
|
|
IP Address | DHCP |
|
|
4.3.4 Set Black Mark Sensor as Media Sensor and Calibrate the Black Mark Sensor
Please follow the steps as below.
1.Turn off the power switch.
2.Hold on the button then turn on the power switch.
3.Release the button when LED turns green/amber after 5 green blinks. (Any green/amber will do during the 5 blinks).
The LED color will be changed as following:
Amber red (5 blinks) amber (5 blinks) green (5 blinks) green/amber (5 blinks) red/amber (5 blinks) solid green
4.3.5Set Gap Sensor as Media Sensor and Calibrate the Gap Sensor
Please follow the steps as below.
1.Turn off the power switch.
2.Hold on the button then turn on the power switch.
3.Release the button when LED turns red/amber after 5 green/amber blinks. (Any
32