The Speaker Company TTP-244CE, TTP-245C 2 Gap/Black Mark Calibration, Self-test and Dump Mode

Page 34

4.3.2 Gap/Black Mark Calibration, Self-test and Dump Mode

While calibrate the gap/black mark sensor, printer will measure the label length, print the internal configuration (self-test) on label and then enter the dump mode. To calibrate gap or black mark sensor, depends on the sensor setting in the last print job.

Please follow the steps below to calibrate the sensor. 1.Turn off the power switch.

2.Hold on the button then turn on the power switch.

3.Release the button when LED becomes amber and blinking. (Any amber will do during the 5 blinks)

The LED color will be changed as following order.

Amber red (5 blinks) amber (5 blinks) green (5 blinks) green/amber (5 blinks) red/amber (5 blinks) solid green

4.It calibrates the sensor and measures the label length and prints internal settings then enter the dump mode.

Note:

Please select gap or black mark sensor by Diagnostic Tool or by GAP or BLINE command prior to

calibrate the sensor.

For more information about GAP and BLINE command, please refer to TSPL2 programming

manual.

28

Image 34
Contents TTP-245C / TTP-343C / TTP-244CE Contents Mark Sensor Copyright Declaration Introduction Product IntroductionIii Operations Overview Unpacking and InspectionPrinter Overview V1.0 MicroSD 512 MB Panasonic Transcend, Panasonic Interior view Rear View Setup Setting up the PrinterOpen / Close the Top Cover Loading the Ribbon Please refer to videos on TSC YouTube or driver CD  Loading Path for Ribbon Loading the Media  Loading path for roll labels External Label Roll Mount Installation Option Page Push the peel-off panel back to the printer Page Loading Media in Cutter Mode Option Diagnostic Tool Function Description Setting Ethernet by Diagnostic Utility Later versionsUsing RS-232 interface to setup Ethernet interface Using Ethernet interface to setup Ethernet interface Page Install SD Memory Card V1.0 MicroSD 256 Transcend, Panasonic 512 LED and Button Functions LED indicatorPower on utilities Regular button functionFunctions 2 Gap/Black Mark Calibration, Self-test and Dump Mode Self-test Gap/black mark sensor intension  Dump mode Parameter Default setting Set Gap Sensor as Media Sensor and Calibrate the Gap SensorSkip AUTO.BAS Troubleshooting LED StatusProblem Possible Cause Recovery Procedure Print QualityMaintenance Printer Part Method IntervalPage Date Content Editor Revise HistoryNo.35, Sec , Ligong 1st Rd., Wujie Township