ThinPrint® Settings
What do you want to do?
To use this service, you must prepare the TPG60. For each end device that uses the Connection Service, you must store the client ID and an authentication key in the database of the Connection Service. You must also set these two values on the TPG60.
Please note that you need a ThinPrint® license for each client ID.
’Configuring the Connection Service via the TPG Homepage’
Ö52
’Configuring the Connection Service via the
Ö52
Configuring the Connection Service via the TPG Homepage
Proceed as follows:
1.Start the TPG Homepage.
2.Select Configuration – ThinPrint®.
3.Tick Connection Service.
4.Enter the relevant data; see: table 5 Ö53.
5.Click Save to confirm.
ªThe settings are saved.
Configuring the Connection Service via the InterCon-NetTool
Proceed as follows:
1.Start the
2.
3.Select Configuration – ThinPrint® from the navigation bar.
4.Select the Connection Service tab.
5.Tick Connection Service.
6.Enter the relevant data; see: table 5 Ö53.
7.Click OK to confirm.
TPG60 User Manual | 52 |