SEH Computertechnik TPG60 user manual Creating Self-signed Certificates via the InterCon-NetTool

Certificate Management

Creating Self-signed Certificates via the InterCon-NetTool

Proceed as follows:

1.Start the InterCon-NetTool.

2.Mark the TPG60 in the print server list.

3.Select Actions – Certificate – Server certificate from the menu bar. The Certificate dialog appears.

4.Tick Create self-signed certificate.

5.Click Next.

6.Enter the relevant parameters, see: table 6 Ö65.

7.Click Next. The parameters are listed.

8.Confirm by clicking Next.

ªThe certificate will be created and installed. This may take a few minutes.

Table 6: Parameters for the Creation of Certificates

Parameter	Description
Common name	Is used to clearly identify the certificate. It is advisable to use the
	IP address or the host name of the TPG60 to allow a clear
	assignment of the certificate to the TPG60. You can enter a
	maximum of 64 characters.
E-mail address	Indicates an e-mail address. You can enter a maximum of 40
	characters. (Optional Entry)
Organization name	Specifies the company that uses the TPG60. You can enter a
	maximum of 64 characters.
Organizational	Specifies the department or subsection of a company. You can
unit	enter a maximum of 64 characters. (Optional Entry)
Locality name	Specifies the locality where the company is based. You can enter
	a maximum of 64 characters.
State name	Specifies the state in which the company is based. You can enter
	a maximum of 64 characters. (Optional Entry)
Country name	Specifies the country in which the company is based. Enter the
	two-digit country code according to ISO 3166. Examples:
	DE = Germany, GB = Great Britain, US = USA
Issued on	Specifies the date after which the certificate is valid.
Expires on	Specifies the date after which the certificate is invalid.

TPG60 User Manual 65