Parameter
Resetting Parameters via an FTP Connection
Proceed as follows:
1.Open an FTP connection to the TPG60: Syntax: ftp <IP Address> Example: ftp 192.168.0.123
2.Enter the password of the TPG60, if applicable, or press ENTER.
3.Reset the parameters: quote SITE RESET
4.Close the FTP connection: quit
5.Disconnect the power socket on the TPG60 for a moment.
ªThe parameters are reset.
Resetting Parameters via the TPG60 Status Button
Proceed as follows:
1.Disconnect the power socket on the TPG60.
2.Keep the status button pressed.
3.Reconnect the power socket on the TPG60. Both LEDs blink rapidly.
4.Release the status button within five seconds. The LEDs blink alternately .
5.Press the status button again.
The parameters are reset. The yellow LED then blinks regularly.
6.Disconnect the power socket on the TPG60 for a moment.
ª The parameters are reset.
TPG60 User Manual | 38 |