FIC A360 service manual Hard Disk Upgrade Procedure, degrees, Installation and Upgrade, screws

Installation and Upgrade

30 degrees

Figure 2-8 Insert Memory Module

5.To remove a SODIMM, press the locking tabs away from the sides of the module until the module pops up. Then, remove the SODIMM.

6.Reassemble the notebook components as follows.

−Put the DIMM door back.

−Replace the screw and turn the system over.

2.3.4Hard Disk Upgrade Procedure

The notebook provides a built-in hard disk for the primary IDE controller. The HDD is an industry standard 2.5” IDE disk drive and can be upgraded with another standard 2.5” HDD.

1.Make sure the system is powered off and that no peripheral devices are attached.

2.Remove the five screws securing the palm-rest cover underneath the system base unit.

screws

Figure 2-9 Remove Palm Reset

3.Remove the palm-rest cover by slowly unsnapping each section of the palm-rest cover from the base unit.

4.When you have remove the entire palm-rest cover, simply flip over the touchpad panel to the keyboard. You will find the built-in hard disk secured with one screw at the upper

2-16 FIC A360 Service Manual