Panasonic WX-C3010 manual Clamping the Power Plug and Power Cord, Connector

■Clamping the Power Plug and Power Cord

Important:

Surely clamp the power plug to this center module and screw the AC cable to the wall using the provided AC cable clamper.

1.Insert an AC cable holder into the hole under the AC inlet.

AC cable holder

3.Insert the power plug into the power cord inlet.

4.Push the holder forward until the holder touches the power plug.

2

3

5. Lock the holder.

2.Slide the holder to the backward by pushing down the clamp lever.

6.Clamp the AC cable with the provided clamp, and secure the AC cable clamper to the wall by fastening the screws.

Slide the holder to the backward by pushing down the lever.

150 mm - 200 mm {5-15/16" - 7-7/8"}

AC cable clamper

●Refer to the following lists attached on the inside of the terminal cover to make connections.

			CONNECTOR 1
		ORDER INTERFACE
AUX SP + (8Ω)	AUX SP GND	OUTSIDE SP + (8Ω)	OUTSIDE SP GND	OUTSIDE MIC +	OUTSIDE MIC –	OUTSIDE MIC GND	V/DET 1 IN	COM	V/DET 2 IN
1	2	3	4	5	6	7	8	9	10

CONNECTOR 2

ORDER INTERFACE

AUX MIC +	AUX MIC –	AUX MIC GND	AUX MIC PTT	COM	DEVICE CONTROL	COM	N.C
1	2	3	4	5	6	7	8

CONNECTOR 3

POS INTERFACE

SPEED TEAM	TALK LOCK RELEASE	MANAGER SELECT	PAGE SELECT	IN COM	POS AUDIO IN	POS AUDIO GND	POS AUDIO OUT	POS AUDIO GND
1	2	3	4	5	6	7	8	9

CONNECTOR 4

POS INTERFACE

V/DET 1	V/DET 2	TALK	PAGE	OUT COM	NIGHT MODE	OUTSIDE SP LEVEL
1	2	3	4	5	6	7

CONNECTOR 5

		N.C			COM
1	2	3	4	5	6

CONNECTOR 6 MAINTENANCE

N.C

CONNECTOR 7 DDT INTERFACE

DOUBLE-DRIVE-THRU Use a LAN cable with the shield type

21