Panasonic WX-C3010 manual Greeter, Method of recording message

Page 13

5.Press the SPEED TEAM button of the Center Module again, the SPEED TEAM mode will be released. The Order Taker or All-in-One Headset allows the operator to hear the voice prompt of the "SPEED TEAM OFF".

Notes:

TALK is prohibited in the speed team mode.

If TALK is attempted with the Order Taker or the All- in-One Headset, a voice prompt of "Operation not allowed" is heard from the headset speaker.

If POS Remote is set for ON, you have to note that no button operation of the speed team is possible at the center module.

Greeter

When the customer approaches the menu board, the voice message recorded in the Center Module is automatically output to the outside speaker. The Center Module has two memories, and you can select either message.

[Method of recording message]

q Greeter On/Off Button

e Greeter Record Button

 

 

GREETER

 

 

ON

START

REC

 

 

DELAY

 

 

SELECT

VOLUME

1

2

DOWN

UP

 

HEADSET

DESTINATION

PLAYBACK

AUX

HEADSET

 

 

w Greeter Memory Select Button

5.Release the PAGE button at the PTP setting. Press the PAGE button again at the PAGE LOCK setting.

When recording is complete, one each of the recorded messages is soon reproduced thereafter.

Notes:

At the time of shipment from the factory, a message of “Please pull forward” is recorded in Message 1.

If any recording is performed on Message 1, the original message will be overridden by the new mes- sage.

No recording is possible during Greeter reproduc- tion.

It must be noted that the talking sound is also recorded if TALK operation is attempted during recording.

[Output setting of Greeter]

q Greeter On/Off Button

e Greeter Output Level Buttons

t Greeter Start Delay Button

 

 

GREETER

 

 

ON

START

REC

 

 

DELAY

 

 

SELECT

VOLUME

1

2

DOWN

UP

 

HEADSET

DESTINATION

 

 

 

PLAYBACK

AUX

HEADSET

r Greeter Output Headset Button

r Greeter Output Auxiliary Speaker Button

e Greeter Playback Button

w Greeter Memory Select Button

r PAGE button of the Order Taker or All-in-One Headset

1.Press the Greeter ON/OFF Button of the Center Module. The Greeter ON/OFF Indicator will light in yellow.

2.Press the Greeter Memory Select Button of Center Module and select the memory 1 or 2.

3.Press the Greeter Record Button of Center Module. The Greeter Record Indicator will light in red.

4.Hold down the PAGE button at the PTP setting. Press the PAGE button at the PAGE LOCK setting. A message can be recorded for 16 seconds at the maximum.

1.Press the Greeter ON/OFF Button of the Center Module. The Greeter ON/OFF Indicator will light in yellow.

2.Press the Greeter Memory Select Button of the Center Module, and select the memory 1 or 2.

3.Press the Greeter Playback Button of the Center Module, and set the output level of message to the optimum level by the Greeter Output Level DOWN/UP Buttons.

4.Set the output destination of the message.

Output to the auxiliary speaker

Press the Greeter Output Auxiliary Speaker Button of the Center Module. The Greeter Output Auxiliary Speaker Indicator will light in green.

Output to the Headset

Press the Greeter Output Headset Button of the Center Module. The Greeter Output Headset Indicator will light in green.

13

Image 13
Contents Operating Instructions Federal Communications Commission Interference Statement ICES-003 Limitation of Liability Disclaimer of WarrantyImportant Safety Instructions Contents Preface FeaturesPrecautions WX-C3010 Center Module Major Operating Controls and Their FunctionsVehicle Detector SP Level Onday UP/DOWN Start DelayDESTINATION, AUX TION, AUXBasic Operation Operating ProceduresConvenient Functions Method of recording message GreeterOutside Speaker Level DAY/NIGHT Vehicle Detector Beep DAY/NIGHTTalk/Page Release Vehicle Detector Normal/Override OnPanasonic WX-C3010 Series System Parts and Accessories Canceller POS Remote Installation procedures Installations/ConnectionsInstallation of center modules on the wall PreparationsMm ± 1 mm 9/32 ± 1/16 Wiring to the center modulesConnector Clamping the Power Plug and Power CordBasic Connection Connector Order InterfacePOS Point of sales-System Connection Connector POS InterfaceCOM Double-Drive-Thru ConnectionID registration for follower units Setup operation for AUX SP Auxiliary Speaker Installed System SettingSetup item On Green OFFIndicator Noise Reduction Sound Quality Remarks Level Indicator Echo Canceller Sound Quality Remarks LevelOn Dual Lane on Green Setup operation for Dual LaneOFF Dual Lane OFF POS Remote setup Lane setupTX Power setup Green Lane BFunctions Terminal names Usage Info about POS Remote functionsSymptom TroubleshootingSymptom Specifications Standard accessories Version Française Déni de la garantie Limitation de responsabilitéInstructions de sécurité importantes Maintenance et caractéristiques techniques Installation et ConnexionsOpérations Caractéristiques dominantes PréfaceMesures de précaution Indicateurs de commande Principaux organes de commande et leurs fonctionsCommandes de volume Module central WX-C3010Personne daccueil Paramétrage opérationnelOutside SP Level Onday #0Bouton denregistrement de personne daccueil REC @9Indicateur denregistrement de personne daccueil rouge RECPlayback Exécution de base Modes dutilisationFonctions commodes Réglage de sortie de personne daccueil Méthode pour enregistrer le messageRemarques Niveau de haut-parleur extérieur DAY/NIGHT Détecteur de véhicule Beep DAY/NIGHTRemarque Activation de détecteur de véhicule normal/asservi Installation et Connexions Paramétrage de système installé Principaux organes de commande et fonctionsLevel Lane Select Enregistrement didentificationID Registration Procédures dinstallation Installations/ConnexionsInstallation des modules centraux sur le mur Configuration de systèmeCâblage aux modules centraux Attache de câble dalimentation secteur Connexions de base POS Points de ventes-Connexion de système Connector 3 POS Interface Connector 4 POS InterfacePassage a Enregistrement didentification pour les appareils suivants Rubrique de configuration On Vert Paramétrage de système installéAucun traitement de léliminateur décho Activé Dual Lane on Vert Opération de configuration de double passageDésactivé Dual Lane OFF Configuration de commande à distance POS Configuration de passageConfiguration dalimentation TX Fonctions prises de connexion Usage Symptôme DépannageOrigine/Solution Pages de Caractéristiques techniques Accessoires standard Page Panasonic Canada Inc Panasonic System Solutions CompanyPanasonic Sales Company