Panasonic WX-C3010 manual ID registration for follower units

Page 25

ID registration for follower units

To talk with the headsets (Order Taker and All-in-One Headset), ID registration is required.

For ID registration, set the center module in ID registration mode and make operation of ID registration by means of a follow- er unit.

ID registration procedures are described below based on the All-in-One Headset.

1. Turn on the power of the Center Module.

Hold down the ID Registration Button for 2 seconds or more.

2.Press the ID Registration Button of the center module for 2 seconds or more. The system is changed to the ID Registration mode. The ID Registration Indicator blinks.

3.While holding down the buttons T1 and T2 simultaneous- ly, hold down the power button to turn on All-in-One Headset. The All-in-One Headset enters the ID Registration setting mode where the indicators and but- tons have different functions than in normal operation. You will hear "ID Registration Mode" and the power indi- cator will blink yellow.

d

Press the Power ON/OFF Switch to turn on.

4.Press the T1 button, the All-in-One Headset searches for the center module. You can hear "Connecting center module A" and the lane Indicator will blink yellow.

*Press the T2 button (at double-drive-thru), for other cen- ter modules. You can hear "Connecting center module B" and the lane indicator will blink green.

When the ID Registration succeeds, you will hear "Registration Complete" and the headset number, and the power indicator stops blinking and stays on.

5.When IDs are registered on all All-in-One Headsets, press the ID button of the center module, ID registration mode is completed. The power indicator of the All-in- One Headset will change from yellow to green.

Notes:

If ID registration fails, a warning sounds "beep, beep, beep, beep" and then you will hear a voice prompt say "Failed". If registration fails, the ID is not registered and the "POWER" indicator blinks red.

If this happens, turn off the power and try registering again.

All-in-one headset or Order Taker that can register in one center module is up to 32.

If you register IDs exceeding 32, the unused ID that has been registered is automatically deleted in chronological order.

When registering the IDs of two or more All-in-one Headset or Order Taker, register each headset or Order Taker in order.

Hold down the Power Button to turn on.

SERVICE

 

USE ONLY

POWER

 

Holding down simultaneously.

25

Image 25
Contents Operating Instructions Federal Communications Commission Interference Statement ICES-003 Limitation of Liability Disclaimer of WarrantyImportant Safety Instructions Contents Preface FeaturesPrecautions WX-C3010 Center Module Major Operating Controls and Their FunctionsVehicle Detector SP Level Onday UP/DOWN Start DelayDESTINATION, AUX TION, AUXBasic Operation Operating ProceduresConvenient Functions Method of recording message GreeterOutside Speaker Level DAY/NIGHT Vehicle Detector Beep DAY/NIGHTTalk/Page Release Vehicle Detector Normal/Override OnPanasonic WX-C3010 Series System Parts and Accessories Canceller POS Remote Installation procedures Installations/ConnectionsInstallation of center modules on the wall PreparationsMm ± 1 mm 9/32 ± 1/16 Wiring to the center modulesConnector Clamping the Power Plug and Power CordBasic Connection Connector Order InterfacePOS Point of sales-System Connection Connector POS InterfaceCOM Double-Drive-Thru ConnectionID registration for follower units Setup operation for AUX SP Auxiliary Speaker Installed System SettingSetup item On Green OFFIndicator Noise Reduction Sound Quality Remarks Level Indicator Echo Canceller Sound Quality Remarks LevelOn Dual Lane on Green Setup operation for Dual LaneOFF Dual Lane OFF POS Remote setup Lane setupTX Power setup Green Lane BFunctions Terminal names Usage Info about POS Remote functionsSymptom TroubleshootingSymptom Specifications Standard accessories Version Française Déni de la garantie Limitation de responsabilitéInstructions de sécurité importantes Maintenance et caractéristiques techniques Installation et ConnexionsOpérations Caractéristiques dominantes PréfaceMesures de précaution Indicateurs de commande Principaux organes de commande et leurs fonctionsCommandes de volume Module central WX-C3010Personne daccueil Paramétrage opérationnelOutside SP Level Onday #0Bouton denregistrement de personne daccueil REC @9Indicateur denregistrement de personne daccueil rouge RECPlayback Exécution de base Modes dutilisationFonctions commodes Réglage de sortie de personne daccueil Méthode pour enregistrer le messageRemarques Niveau de haut-parleur extérieur DAY/NIGHT Détecteur de véhicule Beep DAY/NIGHTRemarque Activation de détecteur de véhicule normal/asservi Installation et Connexions Paramétrage de système installé Principaux organes de commande et fonctionsLevel Lane Select Enregistrement didentificationID Registration Procédures dinstallation Installations/ConnexionsInstallation des modules centraux sur le mur Configuration de systèmeCâblage aux modules centraux Attache de câble dalimentation secteur Connexions de base POS Points de ventes-Connexion de système Connector 3 POS Interface Connector 4 POS InterfacePassage a Enregistrement didentification pour les appareils suivants Rubrique de configuration On Vert Paramétrage de système installéAucun traitement de léliminateur décho Activé Dual Lane on Vert Opération de configuration de double passageDésactivé Dual Lane OFF Configuration de commande à distance POS Configuration de passageConfiguration dalimentation TX Fonctions prises de connexion Usage Symptôme DépannageOrigine/Solution Pages de Caractéristiques techniques Accessoires standard Page Panasonic Canada Inc Panasonic System Solutions CompanyPanasonic Sales Company