Intel N270, FPC 5084 user manual 2 I/O System, System Specification

Page 11

FPC 5084 User Manual

1.2.2 I/O System

￿Standard I/O

￿One RS-232 and one RS-232/422/485

￿Two USB 2.0

￿Ethernet

￿One RTL81111b Gigabit Ethernet

￿Audio

￿One Line-out

￿Expansion

￿One Mini card

￿Storage

￿One socket for CF card

￿Box-header

￿Two 2×5 box header for COM3, COM4

1.2.3 System Specification

￿8.4” TFT LCD

￿Heat Dispensing Design

￿Net Weight

￿1.3 Kgs (2.87 lb)

￿Dimension (Main Body Size)

￿251x205x 44.6mm

￿Operation Temperature

￿0￿ to 45￿

￿Relative Humidity

￿10% to 90% @ 40￿, Non-Condensing

￿Vibration

￿5 to 500 Hz, 2.0 G random for CF card

Introduction

3

Image 11
Contents FPC Disclaimers FCC Compliance Safety ApprovalsSafety Precautions Trademarks Acknowledgments Table of Contents Drivers Installation Memo Reliable and Stable Design General DescriptionMain CPU Board Specifications2 I/O System System SpecificationFPC Dimensions FPC I/O Outlets Packing List CF card Installation Chapter Hardware InstallationHardware Installation Serial Ports Interface Signal Name Ethernet Pin SignalPanel Mounting Mountings Panel/Wall/Desktop/VESAWall-Mounting Desktop-Mounting Hardware Installation VESA-ARM Mounting Vesa mounting Installation completed FPC Dram Installation FPC Wireless LAN Card Installation FPC Memo Page Navigation Keys StartingSystem Time/Date Main MenuAdvanced Menu Hyper Threading Technology Configure advanced CPU settingsExecute-Disable Bit Capability Max Cpuid Value LimitEnhanced C-States IDE ConfigurationSerial Port2 IRQ Serial Port1 AddressSerial Port1 IRQ Serial Port2 AddressSerial Port4 IRQ Serial Port4 AddressSystem Temperature/CPU Temperature Hardware Health ConfigurationAcpi Settings Video Power Down Mode APM ConfigurationPower Management/APM Throttle Slow Clock Ratio Hard Disk Drive Power Down ModePower Button Mode Suspend Time Out MinuteAdvanced Resume Event Controls Resume On Ring Resume On RTC AlarmMPS Revision MPS ConfigurationActive State Power-Management PCI Express ConfigurationSB Pcie Ports Configuration Legacy USB Support USB ConfigurationUSB 2.0 Controller Mode Bios Ehci Hand-OffPCI PnP Menu Allocate IRQ to PCI VGA PCI Latency TimerClear Nvram Plug & Play O/SIRQ3/4/5/7/9/10/11/14/15 Palette SnoopingPCI IDE BusMaster OffBoard PCI/ISA IDE CardBoot Menu Boot Num-Lock Boot Settings Configuration Quick BootQuiet Boot AddOn ROM Display ModeHit ‘DEL’ Message Display Wait For ‘F1’ If ErrorBoot Device Priority Removable Drives Lan Boot Settings Configuration Change User Password Supervisor PasswordUser Password Change Supervisor PasswordBoot Sector Virus Protection Chipset Menu Internal Graphics Mode Select North Bridge Configuration Dram FrequencyConfigure Dram Timing by SPD Boot Graphic Adapter PriorityAMI Bios Setup Utility South Bridge Configuration USB 2.0 Controller Restore on AC Power LossPcie Port Configuration USB FunctionDiscard Changes Exit MenuSave Changes and Exit Discard Changes and ExitLoad Fail-Safe Defaults Load Optimal DefaultsSystem Chapter Drivers InstallationTouch Screen SpecificationDriver Installation- Windows XP FPC Installation of Drivers PenMount Touch screen Embedded O.SWindows XP Embedded Calibration Touch screen Windows CE.NET