Intel N270, FPC 5084 user manual Trademarks Acknowledgments

Page 5

￿Before handling a board or integrated circuit, touch an unpainted portion of the system unit chassis for a few seconds. This will help to discharge any static electricity on your body.

￿When handling boards and components, wear a wrist- grounding strap, available from most electronic component stores.

Trademarks Acknowledgments

ACNODES is a trademark of ACNODES Co., Ltd.

IBM, PC/AT, PS/2, VGA are trademarks of International Business Machines Corporation.

Intel® and Atomare registered trademarks of Intel Corporation. MS-DOS, Microsoft C and Quick BASIC are trademarks of Microsoft Corporation.

VIA is a trademark of VIA Technologies, Inc.

SST is a trademark of Silicon Storage Technology, Inc. UMC is a trademark of United Microelectronics Corporation.

Other brand names and trademarks are the properties and registered brands of their respective owners.

v

Image 5
Contents FPC Disclaimers FCC Compliance Safety ApprovalsSafety Precautions Trademarks Acknowledgments Table of Contents Drivers Installation Memo Reliable and Stable Design General DescriptionMain CPU Board Specifications2 I/O System System SpecificationFPC Dimensions FPC I/O Outlets Packing List CF card Installation Chapter Hardware InstallationHardware Installation Serial Ports Interface Signal Name Ethernet Pin SignalPanel Mounting Mountings Panel/Wall/Desktop/VESAWall-Mounting Desktop-Mounting Hardware Installation VESA-ARM Mounting Vesa mounting Installation completed FPC Dram Installation FPC Wireless LAN Card Installation FPC Memo Page Navigation Keys StartingSystem Time/Date Main MenuAdvanced Menu Execute-Disable Bit Capability Configure advanced CPU settingsMax Cpuid Value Limit Hyper Threading TechnologyEnhanced C-States IDE ConfigurationSerial Port1 IRQ Serial Port1 AddressSerial Port2 Address Serial Port2 IRQSerial Port4 IRQ Serial Port4 AddressSystem Temperature/CPU Temperature Hardware Health ConfigurationAcpi Settings Video Power Down Mode APM ConfigurationPower Management/APM Power Button Mode Hard Disk Drive Power Down ModeSuspend Time Out Minute Throttle Slow Clock RatioAdvanced Resume Event Controls Resume On Ring Resume On RTC AlarmMPS Revision MPS ConfigurationActive State Power-Management PCI Express ConfigurationSB Pcie Ports Configuration USB 2.0 Controller Mode USB ConfigurationBios Ehci Hand-Off Legacy USB SupportPCI PnP Menu Clear Nvram PCI Latency TimerPlug & Play O/S Allocate IRQ to PCI VGAPCI IDE BusMaster Palette SnoopingOffBoard PCI/ISA IDE Card IRQ3/4/5/7/9/10/11/14/15Boot Menu Quiet Boot Boot Settings Configuration Quick BootAddOn ROM Display Mode Boot Num-LockHit ‘DEL’ Message Display Wait For ‘F1’ If ErrorBoot Device Priority Removable Drives Lan Boot Settings Configuration User Password Supervisor PasswordChange Supervisor Password Change User PasswordBoot Sector Virus Protection Chipset Menu Configure Dram Timing by SPD North Bridge Configuration Dram FrequencyBoot Graphic Adapter Priority Internal Graphics Mode SelectAMI Bios Setup Utility South Bridge Configuration Pcie Port Configuration Restore on AC Power LossUSB Function USB 2.0 ControllerSave Changes and Exit Exit MenuDiscard Changes and Exit Discard ChangesLoad Fail-Safe Defaults Load Optimal DefaultsSystem Chapter Drivers InstallationTouch Screen SpecificationDriver Installation- Windows XP FPC Installation of Drivers PenMount Touch screen Embedded O.SWindows XP Embedded Calibration Touch screen Windows CE.NET