Intel FPC 5084, N270 user manual Embedded O.S, Windows XP Embedded, PenMount Touch screen

Page 72

FPC 5084

4.3Embedded O.S.

The GOT-5840T provides the W indows XP Embedded and Windows CE.Net 6.0. The O.S. is supported devices which are listed below.

4.3.1 Windows XP Embedded

Here are supported onboard devices:

Onboard Multi I/O

USB

PS2 Keyboard and mouse

CRT/LCD display(Default 18bits Resolution 800x600)

10/100/1000 base-T Ethernet

Compact Flash

Onboard Audio

Touch Screen

PenMount Touch screen

Before you can use and calibrate it, here is what you should do:

1.Set up Penmount touch device driver by executing C:\Penmount\ Windows 2000-XP V5.0\setup.exe. When the installation is finished, an icon “PM” appears on the Taskbar.

2.Calibrate Penmount touch by clicking on the “PM” icon, and the go on the calibration

3.Restart the computer.

62	Installation of Drivers

Image 72

Contents FPC Disclaimers Safety Approvals FCC ComplianceSafety Precautions Trademarks Acknowledgments Table of Contents Drivers Installation Memo General Description Reliable and Stable DesignSpecifications Main CPU BoardSystem Specification 2 I/O SystemFPC Dimensions FPC I/O Outlets Packing List Chapter Hardware Installation CF card InstallationHardware Installation Serial Ports Interface Signal Name Pin Signal EthernetMountings Panel/Wall/Desktop/VESA Panel MountingWall-Mounting Desktop-Mounting Hardware Installation VESA-ARM Mounting Vesa mounting Installation completed FPC Dram Installation FPC Wireless LAN Card Installation FPC Memo Page Starting Navigation KeysMain Menu System Time/DateAdvanced Menu Configure advanced CPU settings Execute-Disable Bit CapabilityMax Cpuid Value Limit Hyper Threading TechnologyIDE Configuration Enhanced C-StatesSerial Port1 Address Serial Port1 IRQSerial Port2 Address Serial Port2 IRQSerial Port4 Address Serial Port4 IRQHardware Health Configuration System Temperature/CPU TemperatureAcpi Settings APM Configuration Power Management/APMVideo Power Down Mode Hard Disk Drive Power Down Mode Power Button ModeSuspend Time Out Minute Throttle Slow Clock RatioResume On RTC Alarm Advanced Resume Event Controls Resume On RingMPS Configuration MPS RevisionPCI Express Configuration Active State Power-ManagementSB Pcie Ports Configuration USB Configuration USB 2.0 Controller ModeBios Ehci Hand-Off Legacy USB SupportPCI PnP Menu PCI Latency Timer Clear NvramPlug & Play O/S Allocate IRQ to PCI VGAPalette Snooping PCI IDE BusMasterOffBoard PCI/ISA IDE Card IRQ3/4/5/7/9/10/11/14/15Boot Menu Boot Settings Configuration Quick Boot Quiet BootAddOn ROM Display Mode Boot Num-LockWait For ‘F1’ If Error Boot Device PriorityHit ‘DEL’ Message Display Removable Drives Lan Boot Settings Configuration Supervisor Password User PasswordChange Supervisor Password Change User PasswordBoot Sector Virus Protection Chipset Menu North Bridge Configuration Dram Frequency Configure Dram Timing by SPDBoot Graphic Adapter Priority Internal Graphics Mode SelectAMI Bios Setup Utility South Bridge Configuration Restore on AC Power Loss Pcie Port ConfigurationUSB Function USB 2.0 ControllerExit Menu Save Changes and ExitDiscard Changes and Exit Discard ChangesLoad Optimal Defaults Load Fail-Safe DefaultsChapter Drivers Installation System Specification Driver Installation- Windows XP Touch Screen FPC Installation of Drivers Embedded O.S Windows XP EmbeddedPenMount Touch screen Windows CE.NET Calibration Touch screen