Intel FPC 5084, N270 user manual Chapter Drivers Installation, System

Page 68

FPC 5084

CHAPTER 4

DRIVERS INSTALLATION

4.1System

FPC 5084 supports Windows 2000/XP. To facilitate the installation of system driver, please carefully read the instructions in this chapter before start installing.

1.Insert Driver CD and select the “\Drivers\XP”.

2. Select all files and follow the installing procedure.

58	Installation of Drivers

Image 68

Contents FPC Disclaimers Safety Approvals FCC ComplianceSafety Precautions Trademarks Acknowledgments Table of Contents Drivers Installation Memo General Description Reliable and Stable DesignSpecifications Main CPU BoardSystem Specification 2 I/O SystemFPC Dimensions FPC I/O Outlets Packing List Chapter Hardware Installation CF card InstallationHardware Installation Serial Ports Interface Signal Name Pin Signal EthernetMountings Panel/Wall/Desktop/VESA Panel MountingWall-Mounting Desktop-Mounting Hardware Installation VESA-ARM Mounting Vesa mounting Installation completed FPC Dram Installation FPC Wireless LAN Card Installation FPC Memo Page Starting Navigation KeysMain Menu System Time/DateAdvanced Menu Configure advanced CPU settings Execute-Disable Bit CapabilityMax Cpuid Value Limit Hyper Threading TechnologyIDE Configuration Enhanced C-StatesSerial Port1 Address Serial Port1 IRQSerial Port2 Address Serial Port2 IRQSerial Port4 Address Serial Port4 IRQHardware Health Configuration System Temperature/CPU TemperatureAcpi Settings Video Power Down Mode APM ConfigurationPower Management/APM Hard Disk Drive Power Down Mode Power Button ModeSuspend Time Out Minute Throttle Slow Clock RatioResume On RTC Alarm Advanced Resume Event Controls Resume On RingMPS Configuration MPS RevisionPCI Express Configuration Active State Power-ManagementSB Pcie Ports Configuration USB Configuration USB 2.0 Controller ModeBios Ehci Hand-Off Legacy USB SupportPCI PnP Menu PCI Latency Timer Clear NvramPlug & Play O/S Allocate IRQ to PCI VGAPalette Snooping PCI IDE BusMasterOffBoard PCI/ISA IDE Card IRQ3/4/5/7/9/10/11/14/15Boot Menu Boot Settings Configuration Quick Boot Quiet BootAddOn ROM Display Mode Boot Num-LockHit ‘DEL’ Message Display Wait For ‘F1’ If ErrorBoot Device Priority Removable Drives Lan Boot Settings Configuration Supervisor Password User PasswordChange Supervisor Password Change User PasswordBoot Sector Virus Protection Chipset Menu North Bridge Configuration Dram Frequency Configure Dram Timing by SPDBoot Graphic Adapter Priority Internal Graphics Mode SelectAMI Bios Setup Utility South Bridge Configuration Restore on AC Power Loss Pcie Port ConfigurationUSB Function USB 2.0 ControllerExit Menu Save Changes and ExitDiscard Changes and Exit Discard ChangesLoad Optimal Defaults Load Fail-Safe DefaultsChapter Drivers Installation SystemTouch Screen SpecificationDriver Installation- Windows XP FPC Installation of Drivers PenMount Touch screen Embedded O.SWindows XP Embedded Windows CE.NET Calibration Touch screen