Intel N270, FPC 5084 user manual Safety Approvals, FCC Compliance

Page 3

Safety Approvals

￿CE Marking

￿FCC Class A

￿FCC Compliance

This equipment has been tested in compliance with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are meant to provide reasonable protection against harmful interference in a residential installation. If not installed and used in accordance with proper instructions, this equipment might generate or radiate radio frequency energy and cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following methods:

1.Reorient or relocate the receiving antenna.

2.Increase the separation between the equipment and receiver.

3.Connect the equipment to another outlet of a circuit that doesn’t connect with the receiver.

4.Consult the dealer or an experienced radio/TV technician for help.

Shielded interface cables must be used in order to comply with the emission limits.

iii

Image 3
Contents FPC Disclaimers FCC Compliance Safety ApprovalsSafety Precautions Trademarks Acknowledgments Table of Contents Drivers Installation Memo Reliable and Stable Design General DescriptionMain CPU Board Specifications2 I/O System System SpecificationFPC Dimensions FPC I/O Outlets Packing List CF card Installation Chapter Hardware InstallationHardware Installation Serial Ports Interface Signal Name Ethernet Pin SignalPanel Mounting Mountings Panel/Wall/Desktop/VESAWall-Mounting Desktop-Mounting Hardware Installation VESA-ARM Mounting Vesa mounting Installation completed FPC Dram Installation FPC Wireless LAN Card Installation FPC Memo Page Navigation Keys StartingSystem Time/Date Main MenuAdvanced Menu Hyper Threading Technology Configure advanced CPU settingsExecute-Disable Bit Capability Max Cpuid Value LimitEnhanced C-States IDE ConfigurationSerial Port2 IRQ Serial Port1 AddressSerial Port1 IRQ Serial Port2 AddressSerial Port4 IRQ Serial Port4 AddressSystem Temperature/CPU Temperature Hardware Health ConfigurationAcpi Settings APM Configuration Power Management/APMVideo Power Down Mode Throttle Slow Clock Ratio Hard Disk Drive Power Down ModePower Button Mode Suspend Time Out MinuteAdvanced Resume Event Controls Resume On Ring Resume On RTC AlarmMPS Revision MPS ConfigurationActive State Power-Management PCI Express ConfigurationSB Pcie Ports Configuration Legacy USB Support USB ConfigurationUSB 2.0 Controller Mode Bios Ehci Hand-OffPCI PnP Menu Allocate IRQ to PCI VGA PCI Latency TimerClear Nvram Plug & Play O/SIRQ3/4/5/7/9/10/11/14/15 Palette SnoopingPCI IDE BusMaster OffBoard PCI/ISA IDE CardBoot Menu Boot Num-Lock Boot Settings Configuration Quick BootQuiet Boot AddOn ROM Display ModeWait For ‘F1’ If Error Boot Device PriorityHit ‘DEL’ Message Display Removable Drives Lan Boot Settings Configuration Change User Password Supervisor PasswordUser Password Change Supervisor PasswordBoot Sector Virus Protection Chipset Menu Internal Graphics Mode Select North Bridge Configuration Dram FrequencyConfigure Dram Timing by SPD Boot Graphic Adapter PriorityAMI Bios Setup Utility South Bridge Configuration USB 2.0 Controller Restore on AC Power LossPcie Port Configuration USB FunctionDiscard Changes Exit MenuSave Changes and Exit Discard Changes and ExitLoad Fail-Safe Defaults Load Optimal DefaultsSystem Chapter Drivers InstallationSpecification Driver Installation- Windows XPTouch Screen FPC Installation of Drivers Embedded O.S Windows XP EmbeddedPenMount Touch screen Calibration Touch screen Windows CE.NET